Technical data measured at 25° C Model number: Item number: Configuration: Design The multicoupler is housed in a 19” subrack with very good RF shielding and consists of the following subassemblies: RF specifications Impedance (Ohm): - low noise RF amplifiers - power divider 4-way - power supply unit All the necessary signal, power supply and earthing connections are provided at the rear. The mains switch is located on the front panel. Specifications subject to change without notice, 2013-07-24, dble_gta0590.docx Special features The unit is constructed using a modular approach utilising plug-in sub-assemblies which enable ease of installation and maintenance. Frequency range (MHz): Gain (dB): Gain flatness (dB): Noise figure (dB): Intercept point (dBm): 3rd order 2nd order VSWR: Isolation (dB): Out/in Out/out Input power (dBm): 1 dBc Non-destructive Further specifications RF connectors: Power supply (Vac, Hz): Connector Mains switch: Temperature range (°C): Operating EMC: Dimensions: Height (RU) Width (inch) Depth (mm) Front panel: Front view measured a 25° C GTA0590 1300070 2 independent channels each 1 input, 4 outputs 50 Channel 1 1.5…30 1+/-1.0 +/-1.0 max. 8.5 max. Channel 2 20…3000 1+/-2.0 +/-2.0 max. 9.0 max. +40 min. +90 min. 1.5 : 1 max. +12 min. +22 min. 2.0 : 1 max. 30 min. 30 min. 30 min. 15 min. +10 +15 max. 0 max. +10 max. N female, 50 Ohm 195…264/47…63 3-pin, with mains filter & fuses with integrated lamp 0…50 in accordance to Eur. standard EN 55022 & EN 50082-1/2 1 19 about 360 (without connectors & handles) painted (RAL7032) novotronik GmbH • Bäumenheimer Str. 3 • D-86690 Mertingen • Tel. ++49 (0) 9078-9695-0 • Web: www.novotronik.com • E-Mail: [email protected] HF, VHF/UHF Antenna Multicoupler Model The two channel antenna multicoupler is used for compact distribution of two independent RF and VHF/UHF signals. Each channel provides 4 decoupled outputs. The frequency ranges covers 1.5…30 MHz (channel 1) and 20 … 3000 MHz (channel 2).