null null

T-47N
Multi-Function Test Set
Datasheet DESCRIPTION
The T-47N Test Set provides unsurpassed reliability and
ruggedness from over 45 years of experience and proven
results with U.S. and foreign militaries. The Test Set
capabilities allow test and analysis of the following systems:
Transponders (Modes 1, 2, 3A, C, S, and 4 IFF), TACAN
(Tactical Air Navigation), DME (Distance Measuring
Equipment), Interrogator (Modes 1, 2, 3A, C, and 4), and
TCAS (Traffic Alert and Collision Avoidance Systems).
Code of the Day (MODE 4) memory permits full Interrogator
and Transponder tests in actual environments, ensuring
compliance.
New Feature*
The T-47N provides test capability for Mode S Elementary
and Enhanced Surveillance. The T-47N can receive and
display information contained in Mode S DF 17 Extended
Squitter (ADS-B).
P/N: T-47NC 90000061
P/N: T-47NH 90000062
NSN T-47NH: 6625-01-482-4577
TRANSPONDER
•
•
•
•
Fully Tests MODES 1, 2, 3A, C, and 4 (IFF), and MODE S transponders
Direct Connect or Over the Air measurements providing unequaled versatility
”Code of The Day” loaded by KIR and stored in Test Set memory
Accurate displayed results provide meaningful troubleshooting information
The T-47N Test Set performs the following transponder tests based on the capabilities of the Unit-Under-Test:
- Mode 4A/4B - Verifies valid Mode 4A/4B bit and tests to verify valid and invalid properties
- Mode 1 and 2 - Verifies Modes 1 (4 digits) and 2 code and reply efficiency
- MC - Mode C decoded altitude and reply efficiency
- M3A - Verifies 3A reply code, IDENT/EMERG capabilities and reply efficiency
- MA and MC ALL CALL - Mode S Address and reply efficiency
- MA and MC Only
- Mode S Surveillance ID (DF5) – Mode S Address, flight status (Air, Ground, Alert, SPI) and reply efficiency
- Mode S Surveillance Altitude (DF4) – Mode S altitude, flight status, reply efficiency, and Mode S/Mode C altitude compare
- Mode S Surveillance Short (DF0) – Mode S address in octal and hex, decoded tail number, flight status, and reply efficiency
- Mode S Comm Identification (UF5/DF21) – Flight ID Number, flight status and reply efficiency
- Mode S Comm Altitude (UF4/DF20) – Mode S altitude, flight status, altitude compare, and reply efficiency
- Mode S Comm C – decoded tail number, flight status, and reply efficiency
- Undesired replies (UF11) – Checks for no reply to incorrect Mode S interrogation address
- Squitter – Pass/Fail indication of correct squitter period
- Max True Airspeed – Decodes transponder programmable maximum airspeed setting
- Power, Receiver, Sensitivity and Frequency – Displays measured power in dB and watts, frequency, and sensitivity. Pass/Fail indication
- Data and framing pulse measurements are monitored and displayed if out of tolerance.
- SLS (Side Lobe Suppression Test)
- Mode S Enhanced Surveillance parameters including Selected Altitude (BDS4); Roll Angle, True Track Angle, Ground Speed, Track
Angle Rate, and True Airspeed (BDS5); Magnetic Heading, Indicated Airspeed, Mach #, Barometric Altitude Rate, and Inertial Vertical
Velocity (BDS6)
- Receives and decodes 1090 MHz ADS-B data including squitter type (airborne position, surface position, aircraft ident/category, and
airborne velocity), lat/long, N/S velocity, E/W velocity, Flight I.D., Mode S address, altitude (GNSS or barometric), and air speed
Specifications Subject to Change
*DoD AIMS Certification Pending
Copyright © 2007 Tel-Instrument Electronics Corp.
27 June 2007
1 of 4
T-47N
INTERROGATOR
•
Fully tests Mode’s 1, 2, 3A, C, and 4 (IFF)
•
Built in KIV-6 bay for ease of use when testing Interrogators, no need to carry the KIT
•
Easy to use menus and setup features
•
Direct Connect and Antenna-to-Antenna capabilities
•
Manual and Automatic test modes
•
Measures the received pulses and displays pulse width and separation
•
Adjustable range and preset velocity
DME/TACAN
•
Covers entire frequency range for Channels 1 – 126, X and Y
•
Ground to Air (G/A), Air to Air (A/A), and Air to Air Beacon (A/A BCN) Modes
•
Numerous Heading, Bearing, and Range Selections available
•
Accurate Power and Frequency measuring capability
•
Adjustable Reply Rate in 25% increments
TCAS (Traffic Collision Avoidance System)
The ability to test TCAS I, II, and Traffic Alert Systems is standard. The T-47N can simulate both ATCRBS and
MODE S intruders, utilizing an easy to navigate menu and setup procedures. With preset parameters, the Test Set
will automatically simulate an inbound or outbound course allowing the operator to observe an intruder on their
TCAS display and determining correct RA (Resolution Advisory), and TA (Traffic Alert) warnings.
The following features are either preprogrammed or adjustable depending on the operator’s needs:
•
Fully Automated built in TCAS Intruder effectively tests TCAS I, TCAS II, and Traffic Alert Systems
•
Simulates both ATCRBS and MODE S Intruder types
•
Automatic MODE C altitude acquired (with transponder on and operating)
•
Antenna-to-Antenna Operation permitting complete system verification tests
•
Manually adjustable offset allowing ascending or descending intercept scenarios
•
Simple On Screen prompts for easy setup
•
Start/Stop feature allows flexibility in testing for correct bearing information
ADDITIONAL FEATURES
•
Two Models Available, Case Mounted Antenna (NC) or Hand Held Antenna (NH)
•
Diagnostic Self-Test
•
Large, easy to read LCD display
•
Pass and Fail Criteria based on stored parameters
•
Microprocessor control results in easy-to-use operation that requires a minimal amount of training
•
Displays failed criteria
•
Download and save data to a PC through the RS-232 port
•
Rugged and reliable case provides exceptional protection from the elements and rough usage
Specifications Subject to Change
Copyright © 2007 Tel-Instrument Electronics Corp.
27 June 2007
2 of 4
T-47N
PRODUCT SPECIFICATIONS
Transponder Mode
Specification*
Interrogator/TCAS Mode
Specification*
Test Set Transmitter:
Test Set Transmitter:
Output Frequency…………... 1030 MHz ± 10 kHz
Output Power………………... 7 dBm ± 2 dBm Antenna
-42 dBm ± 2dBm Direct Connect
Modes………………………... 1, 2, 3A, C, 4 (IFF), S
Antenna Beam Width………. 15° to 60° ± 10° (variable by
distance from UUT)
Output Frequency…………... 1090 MHz ± 10 kHz
Output Power………………... 7 dBm ± 2 dBm Antenna (TCAS)
-42 dBm ± 2 dBm Direct Connect (TCAS)
Modes………………………... 1, 2, 3A, C, 4 (IFF), S
Antenna Beam Width………. 60° ± 10° typical
Test Set Receiver:
Test Set Receiver:
Frequency
Frequency
Measurement Range………..... 1029.7 to 1030.3 MHz
Measurement Accuracy………. ± 200 kHz
Measurement Range………...1086.5 to 1093.5 MHz
Measurement Accuracy……. ± 200 kHz
Power
Power
Measurement Range……….. 47 to 64 dBm
Measurement Accuracy……. ± 2 dB Direct Connect
± 3 dB Antenna-to-Antenna
Measurement Range………….. 47 to 64 dBm
Measurement Accuracy………. ± 2 dB Direct Connect
± 3 dB Antenna-to-Antenna
Sensitivity
Sensitivity
Measurement Range………...-45 to -87 dBm Direct Connect
-49 to -81 dBm Antenna
Measurement Accuracy……. ± 2 dB Direct Connect
± 3 dB Antenna
Measurement Range………..... -45 to -87 dBm Direct Connect
-55 to -87 dBm Antenna
Measurement Accuracy………. ± 2 dB Direct Connect
± 3 dB Antenna
Reply Efficiency
* Indicates Standard Condition Values as outlined
in Maintenance Manual
Measurement Range……….. 0 to 100%
Measurement Accuracy..……2%
TACAN Mode Specification*
DME Mode Specification*
Test Set Transmitter:
Test Set Transmitter:
Frequency Range…………… 962 to 1213 MHz
Frequency Accuracy……….. ± 10 kHz
Power Out…………………… 0 / ± 2 dBm Antenna
-50 / ± 2dBm Direct Connect
Bearing Accuracy…………… ± 1° typical, ± 2° max.
Range Accuracy…………….. ± 0.5 nmi. typical, ± 1.0 nmi. max.
Velocity Accuracy…………… ± 3%
Antenna Beam Width………...60° ± 10° typical
Frequency Range…………… 962 to 1213 MHz
Frequency Accuracy……….. ± 10 kHz
Power Out…………………… 0 ± 2 dBm Antenna
-50 / ± 2dBm Direct Connect
Range Accuracy…………….. ± 0.5 nmi. typical, ± 1.0 nmi. max.
Velocity Accuracy…………… ± 3%
Antenna Beam Width………. 60° ± 10° typical
Reply Rate…………………… Adjustable to 25%, 50%, 75% and
100% Rates
Freq Measurement…………..±500 kHz Direct Connect A/A
PWR Measurement………….±3 dBm Direct Connect A/A
Specifications Subject to Change
Reply Rate…………………… Adjustable to 25%, 50%, 75% and
100% Rates
Freq Measurement…………..±500 kHz Direct Connect A/A
PWR Measurement………….±3 dBm Direct Connect A/A
Copyright © 2007 Tel-Instrument Electronics Corp.
27 June 2007
3 of 4
T-47N
Physical Characteristics*
Ch
t i ti *
Packaging/Case.…………………………………………………. MIL-PRF-28800F, Class 2
Size…………………………………………………………………14.5 x 9.4 x 8.5 inches
37 x 23.5 x 21.5 cm
Weight………………………………………………………………28 Lbs. (Accessories & Cover)
10.9 kg
Operating Temperature………………………………………….. -28° to +55° C
Battery Type………………………………………………………. Lead-Acid
Battery Life…………………………………………………………8 Hours at 20% Duty Cycle
Battery Charger……………………………………………………Included and built-in
Power requirements……………………………………………… 100 to 125 or 240 VAC, 50 to 400 Hz
12 to 40 VDC
Antenna Configuration……………………………………………Permanently Case Mountable (T-47NC)
Provisions for Case mounting on T-47NH
Tripod Mounted (T-47NH)
Hand-Held (T-47NH)
Colors…………………………………………………………….. Green (T-47NH), Yellow (T-47NC)
* Indicates Standard Condition Values as outlined
in Maintenance Manual
Accessories
Standard
Options
•
•
•
•
•
•
•
•
•
•
•
•
Standard 2-year warranty
Built-In KIV-6 module Bay
KIR/KIT Cable
Operational and Maintenance Manual
Direct Connect Cable
Neck Strap
AC/DC Power Cord
Antenna Handle (NH Only)
Calibrated Directional Antenna
Antenna Extension Cable (NH Only)
5 and 10 Year Warranty Options
Maintenance and Calibration Plans
Tel-Instrument Electronics Corp.
728 Garden Street
Carlstadt, NJ 07072
(201) 933-1600
Leading the Avionics Test Industry into the 21st Century!
For more information on our exciting product lines
Specifications Subject to Change
www.telinstrument.com
Copyright © 2007 Tel-Instrument Electronics Corp.
27 June 2007
4 of 4

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project