9306 Brochure Crops
3-Stud Intelligent Linking Battery Snap-it on... and on... and on...
PAGLINK HC-PL94T TIME BATTERY
• LINK-UP and POWER-UP with new PAGlink 3-stud batteries
• Compatible with the Gold Mount®/ Snap-On® camera plate and Anton/Bauer®
Lithium-Ion chargers
• Smaller, lighter Li-Ion batteries with a higher energy density
• Draw up to 12A for high-current applications (10A individually)
• Combine capacities for longer run-times
• Hot-swap for continuous power
• Charge batteries linked, using Anton/Bauer Li-Ion chargers
(Linked charging was developed by PAG and is an industry first!)
• Fly legally with all the high-capacity UN tested batteries you need
• Camera run-time is displayed numerically in hours and minutes
• Remaining capacity is displayed automatically in the viewfinder/LCD
• Battery firmware can be updated easily in the field
• Intelligent batteries that communicate and manage their own charge and
discharge safely
2
3
SMALLER, LIGHTER & SMARTER BATTERIES
The new PAGlink HC-PL94T is a high-current replacement for all Anton/Bauer
Li-Ion batteries.
PAGlink is the first digital linking battery system. It offers more power, more
functional benefits and more technological advancements than any other
battery system.
The smaller and lighter PAGlink Li-Ion battery is compatible with the Gold
Mount/Snap-On camera plate and with Anton/Bauer Li-Ion chargers; there is
no need to replace expensive equipment in order to benefit from the many
advantages of the new, revolutionary PAG intelligent linking batteries.
4
Actual Size
3 7/16”
5”
2 1/4”
1.6lbs
5
LINK-UP & POWER-UP WITH PAGLINK
Two or more 94 Watt-hour PAGlink batteries, in any state of charge, can be
linked, combining their capacities (2=188Wh), increasing run-time, and
enabling a higher current to be drawn. Up to 12A can be supplied for powerhungry camera set-ups that include multiple accessories. Individual PAGlink
batteries will supply up to 10A.
Two linked batteries provide a longer run-time than two single batteries used
consecutively.
PAGlink also allows batteries to be hot-swapped for continuous power, which
means no more camera reboots while shooting.
6
7
FLIGHT-FRIENDLY HIGH-CAPACITY LI-ION
PAGlink was designed so that flight-friendly 94Wh battery units can be linked
to create a high-capacity Li-Ion power source on location. Linking two HCPL94T packs creates a 188Wh battery. The number of Li-Ion batteries above
100Wh that you can take with you on passenger aircraft is restricted to two,
while Li-Ion batteries that have capacities greater than 160Wh are banned
from passenger flights altogether. PAGlink batteries, which are independently
tested to UN standards, embody unsurpassed safety features and are
unrestricted in quantity by air transport legislation. Every PAG Li-Ion battery
comes with an Air Transport document and features an Air
Safe label which includes the UN Test number.
See paguk.com for Air Transport information.
8
9
CHARGE ALL YOUR BATTERIES ON ONE CHARGER
Up to 8 PAGlink batteries can be linked for charging on each position of your
charger. The PAGlink PL16 is a 2-position Charger/PSU capable of charging
simultaneously up to 16 batteries. Alternatively, your Anton/Bauer Li-Ion
charger* can be used to charge PAGlink batteries whilst linked.
Linked charging was developed by PAG and is unique to the PAGlink system.
All your batteries can be stacked for overnight charging on one charger,
putting an end to midnight battery swapping, and reducing the number of
chargers required to manage all your batteries.
PAGlink batteries display their individual status during charging. The battery
display characters can be rotated with a single button press, for legibility.
* The number of linked batteries that can be charged is dependent on the charger and firmware version.
10
Anton/Bauer Quad Charger
PAGlink PL16 Charger
11
A D VA N C E D T E C H N O L O G Y T H AT ’ S E A S Y T O U S E
Intelligent PAGlink batteries form a network when linked, allowing them to
communicate with each other and manage output safely and efficiently.
The batteries do not discharge into one another.
PAGlink batteries display their remaining capacity in the camera viewfinder and LCD
by communicating automatically with the data system that also allows Anton/Bauer
batteries to do the same.
PAGlink is the first intelligent digital battery system designed for today’s
increasingly computerized cameras; other battery systems are crude by comparison.
PAGlink is also available as a V-Mount system of batteries, chargers and accessories.
Visit paguk.com for details.
12
I N T E R N AT I O N A L PAT E N TS A P P LY
13
ACCURATE RUN-TIME AT YOUR FINGERTIPS
Two button presses onload displays run-time
in hours and minutes
One button press on or
off-load shows capacity
as a percentage
When the battery is fully
charged the display
indicates as above
When the battery is fully
discharged the display
indicates as above
The PAGlink HC-PL94T battery incorporates a convenient numeric display that
with two button presses on-load shows remaining camera run-time in hours and
minutes. When batteries are linked, the run-time figure is for the entire stack,
but a single button press shows individual battery capacity as a percentage, in
one-percent increments. The display maintains accuracy by tracking cellperformance and adjusting calibration values to compensate for cell-aging.
PAG guarantees the PAGlink HC-PL94T Time Battery for 2 years,
without restrictions on the conditions of use.
14
PAGlink HC-PL94T Time Battery Specification
PAG Model No. 9306
Connector Type:
3-Stud / Snap-on®/Gold Mount®
Run-Time & Capacity Display:
On-load, run-time is expressed in hours
and minutes, to a resolution of 1 minute.
Capacity is expressed as a percentage, to
a resolution of 1%.
Construction:
High-impact polycarbonate injection
mouldings designed to protect the cells
from impact damage. The battery case is
sealed to maintain the integrity of the
UN approved construction.
Replaceable Contact Assemblies:
The front and rear contact assemblies are
external to the battery case and can be
replaced as a result of damage.
Cell-Technology:
Premium grade, high-current, sealed,
Lithium-Ion rechargeable cylindrical cells.
Voltage:
14.8V nominal. 12 cells connected in series/
parallel. Each cell has a nominal voltage of
3.7V.
Capacity:
Nominal 6.4 Ampere-hours (94 Watt-hours).
Output Current:
Individual rated maximum continuous
output current 10 Amperes (12 Amperes for
two or more linked batteries).
Charge Voltage:
16.8V.
Charge Times:
Dependent on the battery state of charge,
the charger and the firmware version.
The times given are for fully-discharged
batteries, charged using an Anton/Bauer
sequential Quad® Charger:
1 battery
2 hrs
4 batteries
8 hrs
8 batteries
16 hrs
16 batteries
32 hrs
Protection:
The battery incorporates the following
safety shutdown systems:
3 over-current shutdown systems.
2 over-voltage shutdown systems.
2 under-voltage shutdown systems.
3 thermal shutdown systems, including
non-resetting thermal fuse.
The protection circuit within the battery
has an electrolyte resistant coating.
Firmware Updates:
Battery firmware can be updated in the
field by the user, in a matter of seconds,
via the battery contacts. An update tool
can be supplied by PAG or your dealer.
Updates enable you take advantage of the
technological advances that PAG introduces
to accommodate developments in camera
and charger technology.
Temperature Range:
Charging:
32°F to 113°F (Optimum 50°F to 104°F)
0°C to +40°C (Optimum +10°C to +30°C)
Discharging:
-4°F to +122°F (Optimum 41°F to 104°F)
-20°C to +50°C (Optimum +5°C to +40°C)
Storage:
14°F to 104°F (Optimum 32°F to 68°F)
-10°C to +40°C (Optimum 0°C to +20°C)
Dimensions:
Height
Width
5.00”
3.42”
(129mm)
(87mm)
Depth
2.25”
(58mm)
Weight:
1.6lbs (735g)
15
POWER
I N N O VAT I O N
QUALITY
PAG is one of the broadcast industry’s longest established global providers of innovative
portable power solutions. Founded in 1968, and based in London, England, PAG is the
original designer and manufacturer of the world’s most technologically advanced
batteries, chargers, on-board camera lighting, lighting accessories, battery mounts and
power adaptors. The company’s international customer base includes broadcasting
organizations, video production companies, equipment hire companies, freelancers,
cinematographers, professional videographers, the military and civil authorities.
PAG Ltd.
565 Kingston Road
London SW20 8SA
United KIngdom
E [email protected]
T +44 (0)20 8543 3131
F +44 (0)20 8540 4116
www.paguk.com
Distributor:
© AUG 2015 PAG Ltd.
PAG is a trademark of PAG Ltd. Anton/Bauer, Gold Mount and Snap-On are registered trademarks of Anton/Bauer.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement