TCD - 53 www.denver-electronics.com www.denver

TCD - 53 www.denver-electronics.com www.denver
INSTRUCTION MANUAL
BEDIENUNGSANLEITUNG
BETJENINGSVEJLEDNING
BRUKSANVISNING
SUOMALAISET KAYTTOOHJEET
TCD - 53
www.denver-electronics.com
Copyright. All rights reserved.
www.denver-electronics.com
SUBJECT TO MODIFICATION WITHOUT NOTICE!
DENVER TCD-53 INSTRUCTION MANUAL
A CONTROLS
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
This Compact Disc player is classified as CLASS 1 LASER product.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS 1 LASER APPARAT
CAUTION!
Invisible laser radiation when open and interlocks defeated. Avoid
exposure to beam.
1
2
1. Telescopic aerial
2. CD compartment lid
3. CD open (OPEN)
4. Dial scale
5. Play/Pause button (PLAY/ PAUSE
6. Cassette compartment
7. CD Skip button (
)
8. Repeat indicator (REP.)
9. Play indicator (PLAY)
10. CD Skip button (
)
11. CD Repeat button (REP)
12. Stop button (STOP )
13. Program indicator (PROG.)
14. LED
15. FM Stereo indicator(FM ST.)
16. CD Program button (PROG. )
17. AC input socket (~AC IN)
18. Stereo headphones socket (PHONES )
19. Function/Power switch
(RADIO TAPE CD )
20. Volume control (VOLUME)
21. Band switch (AM FM FM ST)
22. Tuning control (TUNING)
23. Battery compartment
24. Pause button( )
25. Stop/Eject button ( )
26. Fast forward button ( )
27. Rewind button (
)
28. Play button ( )
29. Record button ( )
)
B PRECAUTIONS
3
Read the Operating Instructions carefully and completely
before operating the unit. Be sure to keep the Operating
Instructions for future reference. All warnings and cautions
in the Operating Instructions and on the unit should be
strictly followed, as well as the safety suggestions below.
17
Installation
4
18
19
21
88
20
22
23
24
25
26
27
28
- the heating system has just been turned on
- the unit is used in a very humid room
- the unit is cooled by an air conditioner
When this unit has condensation inside, it may not
function normally. Should this occur, leave the unit for
a few hours, then try to operate again.
29
567
8 9 10 11
13 14 15
English-1
12
16
1 Water and moisture - Do not use this unit near water,
such as near a bathtub, washbowl, kitchen sink, laundry
tub, in a wet basement, swimming pool, or the like.
2 Heat - Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate
heat.
3 Mounting surface - Place the unit on a flat, even surface.
4 Ventilation - The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 10 cm(4 in.) clearance from the rear and the top of
the unit and 5 cm (2 in.) from each side.
- Do not place the unit on a bed, rug, or similar surface
that may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet,
or airtight rack where ventilation may be impeded.
5 Objects and liquid entry - Take care that objects
or liquids do not get inside the unit through the
ventilation openings.
6 Condensation - Moisture may form on the CD Pickup
lens when:
- The unit is moved from a cold spot to a warm spot
Electric Power
1 Power sources - Use on batteries or AC house current,
as specified in the Operating Instructions and marked
on the unit.
2 AC power cord
- When disconnecting the AC power cord, pull it out by
the AC power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as
this could result in fire or shock.
- Power cords should be firmly secured to avoid being
bent, pinched, or walked upon. Pay particular attention
to the cord from the unit to the power socket.
- Avoid overloading AC power plugs and extension
cords. beyond their capacity, as this could result in fire
or shock.
3 When not in use - Unplug the AC power cord from the
AC outlet or remove all the batteries if the unit will not
be used for several months or more. When the cord is
plugged in ,a small amount of current continues to flow
to the unit, even when the power is turned off.
English-2
C POWER SUPPLY
F TUNER OPERATION
IMPORTANT
Make sure that function is set to TAPE before connecting
the AC cord or inserting batteries.
The batteries need to be replaced when:
The tape speed slows down, volume decreases, or
sound is distorted during operation.
1 Set function to RADIO.
2 Select a band with BAND.
3 Tune to a station with TUNING.
4 Turn VOLUME to adjust the sound.
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
Using on batteries
Open the lid of the battery compartment on the bottom and
insert eight (size C) batteries, not supplied, with the and
marks correctly aligned. then close the lid.
To switch from AC power supply to battery power supply,
disconnect the AC cord from the AC inlet of the unit.
notes on batteries
Do not mix different types of batteries or old batteries
with new ones.
Never recharge the batteries, apply heat to them or
take them apart.
Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
For better reception - Extend the FM antenna and orient
it for the best reception; AM antenna is inside the unit.
Position the unit for the best reception.
NOTE
FM /FM ST
Sets the FM sound to stereo or monaural.
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent ligts, move the unit away.
G TAPE OPERATION
Use Type 1 (normal) tapes only.
PLAYING BACK A TAPE
D MAINTENANCE
To clean the cabinet
Cassette tapes
Use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol.
benzine or thinner.
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver
or other pointed tool.
To clean the heads and tape paths
After every 10 hours of use, clean the Recording heads
and Playback head , the pinch roller and capstan .Use
a cotton swab 5 slightly moistened with cleaning fluid
or denatured alcohol.
FM ST: Reception is stereo. When receives FM stereo
signal, the FM ST indicator lights up.
FM: When an FM stereo broadcast contains noise,
set to FM. Noise is reduced, although reception is
monaural.
To record on the tape again, cover the tab openings with
adhesive tape, etc.
1 Set function to TAPE.
2 Press
STOP/EJECT to open the cassette
holder and insert a tape with the exposed side up and
the side to be played facing out.
3 Press PLAY to start play.
4 Turn VOLUME to adjust the sound.
STOP/EJECT - Stops play.
PAUSE - Pauses play. To resume play, press again.
F FWD/
REW - Fast forwards/rewinds. To
stop winding. press
STOP/EJECT.
RECORDING
Note that recording is done on only one side of the tape.
1 Insert a tape with the side to be recorded facing out.
Wind up the tape to the point where recording starts.
2 Get ready to record from the source.
To record from a CD: set function to CD and start play.
To record from the tuner: set function to RADIO and
tune to a station.
3 Press REC to start recording.
PLAY is pressed simultaneously.
To stop recording, press
STOP/EJECT.
To erase a recording, set function to TAPE and start
recording.
H GENERAL
To turn off the unit completely, set function to TAPE with all cassette keys released.
To listen with the headphones, connect headphones with a stereo mini plug to the PHONES jack.
If an erroneous display or malfunction occurs, disconnect the AC cord and remove all the batteries to turn off the
display. Then turn the power back on.
E CD OPERATION
1 Set function to CD.
2 OPEN the disc compartment and place a disc with
the printed side up. The total number of tracks
is displayed.
3 Press
PLAY/PAUSE to start play- the indicator
lights up:
The number of the track being played is displayed.
4 Turn VOLUME to adjust the sound.
STOP - Stops play.
PLAY/PAUSE - Pauses play. To resume play, press
again.
SKIP/SEARCH - Searches for a particular
,
point during playback. Keep
or
pressed and then
release it.
- Skips to the beginning of a track. Press
or
repeatedly
PROGRAM
In stop state, press PROGRAM, the indicator lights up
and flashes ,use skip/search to select the track you wish
to program . Press PROGRAM. button to memorize the
track you choose. Repeat this step for more tracks you
wish to program.(maximum up to 20 tracks )Then press
PLAY to start.
To erase the programmed tracks, Press STOP and open
the CD door.
NOTE
REPEAT
Press REPEAT once- the indicator lights up and
flashes: A single track is played repeatedly. Select
a track with
or
.
Press REPEAT twice- the indicator lights up:
All tracks are played repeatedly.
English-3
Do not use irregular shape CDs(example: heart-shaped,
octagonal ones). It may result in malfunctions.
Do not place more than one disc in the disc
compartment.
Do not try to open the disc compartment during play.
Do not touch the lens. Doing so may cause malfunctions.
COPYRIGHT
Please check the copyright laws relating to recordings from disc, radio or external
tape for the country in which the machine is being used.
I SPECIFICATIONS
Tuner section
Frequency range:
Deck section
Track format:
Frequency range:
Recording system:
Erasing system:
Heads:
CD player section
Disc:
Scanning method:
FM : 88-108 MHz
AM : 525-1635 KHz
4 track, 2 channels
Normal tape
DC bias
Magnet erase
Recording / playback head
Erasure head
Compact disc
Non-contact optical scanner
(semiconductor laser)
General
Speaker:
77 mm cone type (2)
Output:
Headphones jack (stereo jack)
Power output:
1.0 W +1.0 W
Power requirements: DC 12 V using eight size C batteries,
AC 230V, 50Hz
Weight:
2.4Kg (excluding batteries)
Dimensions:
290(W)x160(H)x250(D) mm
Accessory:
AC cord (1)
Specifications and external appearance are
subject to change without notice.
English-4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement