SILICON VIDEO® WGA High Dynamic Range Cameras

SILICON VIDEO® WGA High Dynamic Range Cameras
SVWGAC
Monochrome Camera SVWGAM
Color Camera
SILICON VIDEO WGA
High Dynamic Range Cameras
®
PIXCI® SI2
Frame Grabber
PCIe x1
PIXCI® SI1
Frame Grabber
PCIe x1
SVWGA Camera
(Lens Optional)
PIXCI® SI4
Frame Grabber
PCIe x4
Optical Format:
Active Image Size:
PIXCI® SI
Frame Grabber
PCI Bus
1/3-inch
4.51mm(H) x 2.88mm(V)
5.35mm Diagonal
Active Pixels:
752H x 480V
Pixel Size:
6.0µm x 6.0µm
Color Filter Array:
Monochrome or Color RGB Bayer Pattern
Shutter Type:
Double-Buffered Global Shutter
Maximum Data Rate:
324 Megabits per second
Master Clock:
26.6 MHz
Full Resolution:
752 x 480
Frame Rate:
60 fps (at full resolution)
ADC Resolution:
10-bit
Responsivity:
4.8 Volts/Lux-sec (550nm)
Dynamic Range:
>55dB Linear
>80dB-100dB in HiDy Mode
Supply Voltage:
5 to 12 Volts
Power Consumption:
320 mW at maximum data rate
Operating Temperature: -40oC to +85oC
Camera Dimensions:
2.50” L x 1.65” H x 0.81” D
63.50mm L x 41.75mm H x 20.60mm D
Weight:
1.4 oz / 39 grams
The SILICON VIDEO® WGAC (color) and WGAM (monochrome)
cameras provide up to 752 pixel by 480 line images with up to 10
bits of grey scale per pixel in a progressive scan format at frame
rates from 60 frames per second or up to 1338 frames per
second at reduced resolution. The area of interest and pixel clock
are programmable to allow tradeoffs in image size and image
quality against frame rate. The camera has a global shutter for
exposures as short as 27 microseconds. The camera can be
programmed for linear or companded modes of operation. Linear
mode provides precise intensity and color control which provides
better image quality. Companded mode, combined with automatic
gain and automatic exposure, allows the camera to automatically
respond to changing image illumination. Our software provides
control of all camera operations.
Asynchronous Capture with Strobe Output
The SVWGAC and SVWGAM cameras offer asynchronous
capture to acquire an image (or images) in response to a trigger
signal. The cameras have a strobe output signal to synchronize
an LED strobe.
One RJ45 Cable and 4 Frame Grabbers
A single RJ45 cable connects the camera head to a PIXCI® frame
grabber. It provides power to the camera, carries camera
controls, carries the programmable pixel clock, and carries video.
No separate power supply or power cable required. The SVWGA
cameras are supported by 4 different PIXCI® SI series frame
grabbers allowing use on either the PCI or PCIe bus. The PIXCI®
SI supports one camera in a 32 bit PCI slot. The PIXCI® SI1 and
SI2 frame grabbers support one or two cameras in a PCIe x1 slot.
The PIXCI® SI4 supports 4 cameras on a PCIe x4 or wider slot.
Camera Controls
The XCAP-Lite sofware included with a PIXCI® frame grabber has
a Capture & Adjust Dialog for selecting capture mode, ADC,
AGC, and AEC control, pixel clock frequency, integration/exposure time, capture resolution, trigger control, slope selection and
more. The SVWGAC color camera dialog provides automatic
white balance, manual adjustment of Red, Green, and Blue gain,
and extensive color balance controls.
Lens Optional
Add a 1/3" format C-Mount lens, programmer libraries, image
processing, or video to disk and image analysis software, or
request a complete computer system. EPIX, Inc. assembles
imaging systems, built to your specifications, with cameras, frame
grabbers, high-performance motherboards, and RAID arrays for
video to disk capture.
SVWGA Global Shutter / High Dynamic Range Cameras
CAMERA CONTROL SOFTWARE
Sequence Capture with SVWGA Camera
and XCAP Imaging Program Versions
A SILICON VIDEO® WGA camera will capture continuously, at various resolutions and
frame rates, as shown in the chart to the right.
XCAP-Lite will capture for almost 3 seconds at 752 x 480 resolution, 8 bits per pixel, 60 fps.
Images must be saved individually. XCAP-Lite is included with the PIXCI® SI series frame
grabbers.
The XCAP-Ltd program captures and saves sequences for more than 6 minutes into 8
GBytes of available memory (computer must have approximately 12 GBytes of installed
memory). XCAP-Ltd is $495.
The XCAP-Std imaging program offers video to disk capture, which can allow continous
capture for hours depending on the capacity of the computer’s storage system.
XCAP-Std is $1495. Select which version of the XCAP program is best for your application
by reviewing the description at http://www.epixinc.com/products/xcap.htm.
SVWGAC & SVWGAM
Global Shutter Color/Mono Cameras
Frame
Resolution
752 x 480
640 x 480
600 x 450
500 x 374
400 x 300
320 x 240
240 x 180
160 x 120
80 x 60
40 x 30
752 x 2
Pixel Clock Frequency
25 MHz
26.6 MHz
38 MHz
Slowest
Default
91 fps
59 fps
63 fps
105 fps
69 fps
74 fps
116 fps
81 fps
76 fps
137 fps
90 fps
96 fps
109 fps
116 fps
166 fps
202 fps
132 fps
141 fps
255 fps
179 fps
168 fps
348 fps
229 fps
244 fps
360 fps
383 fps
548 fps
505 fps
537 fps
767 fps
669 fps
711 fps
1016 fps
50 MHz
Fastest
119 fps
139 fps
153 fps
180 fps
219 fps
265 fps
336 fps
459 fps
721 fps
1010 fps
1338 fps
SILICON VIDEO® WGA Monochrome Camera
Typical Quantum Efficiency
SILICON VIDEO® WGA Color Camera
Typical Quantum Efficiency
GretagMacbeth Color Checker
captured by SVWGAC camera.
Full dynamic range with excellent
color quality.
Specifications subject to change without notice. EPIX and
PIXCI are registered trademarks of EPIX, Inc. XCAP is a
trademark of EPIX, Inc. EPIX ® imaging products are made
in the USA. © 2011 EPIX, Inc.
All Rights Reserved. 20 MAR 2011
EPIX, Incorporated
381 Lexington Drive
Buffalo Grove, IL 60089 USA
Tel - 847 465 1818
Fax - 847 465 1919
[email protected]
www.epixinc.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement