INSTALLATION INSTRUCTIONS

Product

7160-0448, 7160-0449

VISOR MOUNTS - CAPRICE

Revision

Rev.A

Form

INST-583

Printing Spec: PS-001

The Caprice Visor Mounts 7160‐0448 & 7160‐0449 provide the user with the capability to secure a mobile camera to the passenger side visor.  Each system includes a Max

3

 all axis knuckle that allows the user to  orient the camera in several positions.  The 7160‐0448 mount, includes a second knuckle to mount a display. 

 

Tools Needed 

5/64‐in Hex wrench (Allen wrench)

 

3/16‐in  Hex wrench (Allen wrench) 

Small Flat Screwdriver or Knife 

Installation 

Material Needed

#10 Self drilling screws

1. Remove the passenger side visor retainer clip near the center of the vehicle headliner.  The clip is  assembled with a wedge/pin which must be pried out with a small flat screwdriver or knife blade. 

Also remove the metal clip inserted into the cutout in the headliner. Refer to FIG 1, 2 & 3. 

2. Reassemble the metal clip and the visor retainer clip to the plate supplied with the Caprice Visor 

Mount Assembly. 

3. Position the Visor Mount Assembly over the cutout in the headliner so the metal clip extends into  the headliner cutout FIG 5.  

4. Secure the Visor Mount to the headliner using a minimum of four self‐tapping fasteners FIG 4 & 5.   a. Self‐tapping fasteners are not supplied.  b. Caution:   Self tapping fasteners that are too long may go through roof of vehicle. 

5. Secure the camera to the front camera bracket using (2) ¼‐20 x .50 socket button head cap screw, 

(2) ¼‐in lock washer, and (4) ¼‐in nylon flat washers.  Refer to FIG 4. 

6. Position the camera as desired.  

7. Secure the display to the display bracket using hardware supplied by the display manufacturer 

(7160‐0448 units). 

8. Insert and tighten #10‐32 socket head set screws to lock the Max

3

 knuckles in place. 

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2012 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

1 / 2

FIG. 1

Metal Clip

Visor Retainer Clip

Wedge/Pin

Metal Clip Cutout in Headliner

FIG. 2

Visor Clip Plate

FIG. 3

Visor Mount

.25-20 Screws & Washers

FIG 4

FIG. 5

#10 Self-Tapping Hardware supplied by Customer

2 / 2