- No category
advertisement
Bedienungsanleitung manual
Funkregler Empfänger/ wireless thermostat FUNK
D
Einlernen des Empfängers
Einlernen eines Raumthermostaten Drücken Sie am Empfänger länger als 3 Sekunden die
Taste bis die Kontrollleuchte zu blinken beginnt. Anschliessend bringen Sie den Sender in
Konfigurationsmodus (siehe Bedienungsanleitung Sender). Wenn die Kontrollleuchte am
Empfänger nicht mehr blinkt, sind die beiden Produkte zugeordnet.
Einlernen eines Domotiksender
Drücken Sie am Empfänger länger als 3 Sekunden die Taste bis die Kontrollleuchte zu blinken beginnt 2 Betriebsarten sind möglich; Langsames Blinken: Ein/Aus Schalter -
Schnelles Blinken: Impulsgeber.
Zum Umschalten der Modi, Taste kurz drücken. Bringen Sie den Sender in den
Konfigurationsmodus (Siehe Bedienungsanleitung Sender). Überprüfen Sie, dass die
Kontrollleuchte am Empfänger nicht mehr blinkt.
Anwendungsbeispiel:
Bei Verwendung eines Raumthermostaten und eines Öffnungsmelders wird durch den
Öffnungsmelder der Thermostat auf Frostschutz geschaltet solange das Fenster geöffnet ist.
Die Funktionsweise des Relais kann umgeschaltet werden (Öffner/Schliesser). Drücken Sie hierzu die Taste des Empfängers ca. 10 s bis das Relais schaltet und die Kontrollleuchte nicht mehr blinkt.
Zuordnungen Löschen
Zum Löschen aller zugeordneten Produkte Drücken Sie die Taste des Empfängers ca. 30 sek. bis die Kontrollleuchte kurz aufblinkt. Alle Sender sind nun gelöscht.
EN
Associating the receiver
With a transmitter thermostat Press the receiver button until the LED flashes (~3 seconds).
Put the transmitter into association mode (see transmitter guide). Check that the receiver LED is no longer flashing. The receiver is associated with the transmitter.
With a control system transmitter
Press the receiver button until the LED flashes (~3 seconds). 2 possible choices. Slow flashing: simple lighting mode Rapid flashing: pulse mode. Press the receiver button briefly to pass from One rate of flashing to the other.
On the transmitter, send the association radio information (see transmitter guide). Check that the receiver’s LED is no longer
Flashing.
Application example: with a door/window magnetic contact. When associated with the receiver, the magnetic contact can: - in control system mode, report the magnetic contact's status
(open/closed), - in heating mode, for instance when there is an open window, switch the heating to frost protection.
Removing all the receiver associations
Press and hold the button. The LED flashes after 3 seconds.
Hold down the button. The relay reverses after 10 seconds and the LED no longer flashes
(reverse current relay mode active). Hold down the button.
The LED flashes after 30 seconds; all the associations are removed. Release the button.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project