Selve i-Marki Control W / WS Owner's Manual

Below you will find brief information for sun protection control i-Marki Control W, sun protection control i-Marki Control WS. The i-Marki Control W/WS, delivered from the factory with the current date and time (GMT), operates your sun protection system on the basis of sunlight intensity and wind speed. Battery operation makes it also possible to programme the unit when the operating device is disconnected since the display is maintained. During the initial startup, the i-Marki Control W/WS will be in automatic mode. The sun protection system's end position and intermediate position, canopy tension/tilt position, and automatic summer/winter time changeover can all be programmed.

PDF Download
Document
i-Marki Control W, i-Marki Control WS Operating Instructions | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Automatic operation based on sunlight intensity and wind speed
  • Battery operation for programming with disconnected operating device
  • Programmable end position and intermediate position for sun protection system
  • Programmable canopy tension/tilt position
  • Automatic summer/winter time changeover

Frequently asked questions

The i-Marki Control is a device that automatically controls your sun protection system based on sunlight intensity and wind speed.

To set the time and date, simply press the MENU button and select the TIME/DATE menu. Use the +/- buttons to adjust the time and date, and then press the OK button to confirm your settings.

The i-Marki Control WS model includes a built-in wind sensor, while the i-Marki Control W model does not. The WS model allows for more precise control of the sun protection system based on wind conditions.

To program the end position, press the MENU button and select the SETTINGS menu. Use the +/- buttons to adjust the settings for the end position and then press the OK button to confirm your settings.

To program the intermediate position, press the MENU button and select the SETTINGS menu. Use the +/- buttons to adjust the settings for the intermediate position and then press the OK button to confirm your settings. You can also manually reach this position by pressing the DOWN button twice in rapid succession.

To program the canopy tension/tilt position, press the MENU button and select the SETTINGS menu. Use the +/- buttons to adjust the settings for the canopy tension/tilt position and then press the OK button to confirm your settings. You can also manually reach this position by pressing the UP button twice in rapid succession.

To activate or deactivate the automatic summer/winter time changeover, press the MENU button and select the SETTINGS menu. Use the +/- buttons to toggle between ON and OFF, and then press the OK button to confirm your selection.
Preparing document for printing…
0%