null  null
INSTAL L ATI ON
I NSTRU CTI ONS
Adjustable Wall Mount Standard
DOOR GUIDE
Installed as a Come Along-Style Door Guide
To be installed on wood doors
with a mortise running along the bottom of the door
hung on a Bypass Track System
RH
•••••••••••••••••••••••••••••••••••••••••
PA R T S A N D T O O L S
I N S TA L L AT IO N
IN S T RUC T IO N S
Tools Needed
Pencil
Tape Measure
Drill with Phillips bit
Parts Included
Door Guide
Grabber Screws
End Plates
NOTE: This Wall Mount Door Guide will be installed on the
front of your Door that is closest to the wall (instead of being
installed onto your wall).
RH
•••••••••••••••••••••••••••••••••••••••••
HD
AO
NG
LE
OE
RRGHUOI D
ES
I N S TA L L AT I O N
I N S T RU C T I O N S
1. Installing Your Door Guide
Door
Edge
Front of
Back Door
Wall
Door
Opening
• Slide both doors to the open position. Slide the back door
(closest to the wall) out several inches to gain access to
the Door. This is where you will install the Guide.
• On the back Door, Pencil a line 1-1/16” parallel to the
edge of the door that is closest to your Door opening.
• With the edge of the Bracket back lined up with the line
you just penciled, shift the Bracket up slightly so the
mortise (see below) along the bottom of the front Door will slide over the vertical Bracket edge.
• With a Phillips drill bit, drill a Grabber Screw into each
hole in the Bracket back plate.
1-1/16”
from Door
edge
vertical Bracket edge
A mortise is the channel
that runs along the bottom
of your Door.
2. Aligning Front Door Over Door Guide
• Slide front Door so the mortise along the bottom of
the Door slides over the vertical Bracket edge.
Front of
Back Door
Door
Edge
Wall
Door
Opening
Front
Door
Edge
vertical Bracket edge
RH
•••••••••••••••••••••••••••••••••••••••••
Back
Door
Edge
HANGER HOLES
I N S TA L L AT I O N
I N S T RU C T I O N S
1. Installing End Plates
• Position one of the End Plates over the
bottom edge of the front Door, aligning
the bottom of the Bracket with the
Bottom of your Door.
The mortise along the bottom
of the front Door glides over to
cover the vertical Bracket edge.
• Using your drill with a Phillips bit, drill
a Grabber Screw into each of the two
holes in the End Plate.
• Attach the other End Plate on the
opposite edge of this Door, aligning the
bottom of the End Plate with the
bottom of the Door, covering the
mortise.
RH
•••••••••••••••••••••••••••••••••••••••••
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement