triadatm bollard
TRIADA BOLLARD
TM
SURFACE MOUNT INSTALLATION INSTRUCTIONS
MATERIALS INCLUDED
TOOLS NEEDED
a
b
STEP BY STEP
c
5/32" hex bit
for tamper-resistant
screws
d
socket wrench
template
(upon request)
3/4" socket
FOR ALL TRIADA BOLLARDS
1-1/4"
MINIMUM
DIAMETER
a
DEPTH
Pour concrete footer
Insert J-bolt anchors
Slide base plate onto J-bolt anchors
• Mix and pour concrete footer according
to concrete manufacturer’s instructions.
• Insert 1/2"-13 x 18" galvanized steel
J-bolt anchors (a) into concrete.
• Slide base plate over J-bolt anchors and
lower to concrete level.
• A sufficient footer size depends on frost
and other conditions to be determined by
the installer. A minimum of a
13" diameter x 20" deep footer is
recommended.
• Use template (included) to position J-bolt
anchors in proper locations. Tops of
J-bolt anchors must be a minimum of
1-1/4" above concrete surface.
• Allow concrete to set completely, in
accordance with concrete
manufacturer’s instructions, before
moving to step 3.
NOTE: Bollards and base plates are
pre-matched during the manufacturing
process to ensure the best fitment. For
best end result, please keep base plates
and bollards in the same pre-matched
sets throughout installation.
T 800.451.0410 | www.forms-surfaces.com
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
page 1 of 2 | Rev. 01-22-16
TRIADA BOLLARD
TM
SURFACE MOUNT INSTALLATION INSTRUCTIONS
STEP BY STEP
FOR ALL TRIADA BOLLARDS
c
b
d
d
Attach base plate & tighten
Slide bollard onto base plate
Attach bollard to base plate
• Slide 1/2" washer (b), then thread 1/2"13 nut (c) onto each J-bolt anchor.
• Slide bollard over base plate and
lower.
• Thread 1/4"-20 x 3/4" tamper-resistant
flat head cap screw (d) into each hole.
• Use socket wrench and 3/4" socket to
tighten all nuts until snug.
• Use provided 5/32" hex bit for tamperresistant screws to tighten all screws
until snug.
T 800.451.0410 | www.forms-surfaces.com
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
page 2 of 2 | Rev. 01-22-16
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement