SC-228W Ultra Thin Antenna - User Guide

SC-228W Ultra Thin Antenna - User Guide
SureCall Ultra Thin Antenna™ (SC-228W)
Full-Band Omni-directional Ceiling-Mount Inside Antenna
Installation
Overview
Designed to blend seamlessly into any environment, the SureCall Ultra Thin Antenna™
is a low-profile ceiling-mount antenna for in-building cell phone signal boosters.
The wide band indoor antenna transmits and receives signal in a 360 degree pattern
and is designed to cover 2G/3G/4G and WLAN systems for Cellular, PCS, AWS and
LTE frequencies.
»
»
»
»
»
N-Female connector (50 ohm)
3.5 dBi / 7.5 dBi Gain
Wide band: 2G, 3G & 4G LTE (698 - 2700 MHz)
Includes mounting hardware
Connects to booster with SC-400 cable (sold
separately)
Specifications
1. Drill a center-hole. The size should be large enough to allow the antenna’s threaded
plastic cable base to pass through.
SC-400
CABLE
2. Assemble the antenna as shown in the illustration with foam ring
and metal mounting plate (with interlocking pegs facing down).
3. Push antenna to ceiling surface with antenna cable
passing through ceiling.
4. From crawl space, use the threaded fixing
nut to secure antenna by tightening
around the threaded plastic cable base.
5. Connect female antenna connector with
low-loss cabling.
THREADED
FIXING NUT
METAL
MOUNTING
PLATE
FOAM
ANTENNA
Frequency
698-960 / 1710-2700 MHz
Input Impedance
50 Ohm
Max Gain
3.5 dBi / 7.5 dBi
Non-Circularity
±2.5 dB / ±4.0 dB
Beamwidth
360 degrees
VSWR
≤1.7
Polarization Type
Vertical
Radiation Pattern
Omni-directional
Connector Type
N-Female
Height
1.45"
Diameter
11.8"
Weight
1.19 lbs
Cover Material
PC+ABS
Mount Type
Ceiling
Install guidelines
Besides the antenna itself, parts include mounting options for an install that is accessible by
crawl space or one that is not. Optimally, It should be located central to where signal is
needed with minimal obstacles. The range of this antenna is dependent on three factors:
1. Physical obstructions
2. Power generated by booster
3. Signal level received by the outdoor antenna
2014 V1.0
If accessible by crawl space:
© SureCall | Fremont CA 94538 | www.surecall.com | 1-888-365-6283 | [email protected]
If not accessible by crawl space:
1. Drill a center-hole. The size should be large enough to allow the antenna’s plastic cable
base to pass through.
2. Use metal mounting plate to align, mark and drill 3 holes into ceiling surface and insert
provided anchors.
3. Secure metal mountings plate to ceiling by inserting provided screws through mounting
plate (with interlocking pegs facing down) and into ceiling anchors.
4. Place foam ring onto antenna as shown in illustration B.
5. Push antenna to bracket surface allowing cable to pass through ceiling hole. Align
keyhole mounts on the antenna with down-facing pegs and twist into place.
6. Connect female antenna connector with low-loss cabling.
A.
B.
METAL MOUNTING
PLATE
SCREWS
FOAM
ANTENNA
SC-400
CABLE
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement