LENS ADAPTER MANUAL
LENS
ADAPTER
MANUAL
LA-CEF-LR
LA-MFT-LR
2
INTRODUCTION
Thank you for choosing a Vello Lens Adapter. Vello lens adapters allow you to use lenses from
manufacturers other than the maker of your camera body, so you can mount a lens on a camera
body with which it would otherwise be incompatible. Vello Lens Adapters fit securely to the
lens, but not so tightly that they are difficult to remove. Please follow these instructions to
mount and remove your Vello Lens Adapter.
Although the lens will fit physically, automatic diaphragm (AE metering), and other functions dependent
on communication between the camera body and lens, will be disrupted by a lens adapter. You will
need to set exposures manually or meter in aperture priority (stop-down) mode. Focusing to infinity
is retained.
All images are for illustrative purposes only.
3
TO MOUNT THE LENS ADAPTER
Note: Place the lens on a stable, flat surface when mounting or removing your Vello Lens Adapter.
1.Line up the release tab on the lens adapter
with the red alignment dot on the lens.
2.Rotate the lens adapter clockwise until it
locks into place.
4
3.Line up the alignment dots on the lens
adapter and the camera.
4.Rotate the lens assembly clockwise until it
locks into place.
5
TO REMOVE THE LENS ADAPTER
1.Press the lens release button on the
camera.
2.Rotate the lens assembly
counterclockwise to release.
6
3.Lift and hold the release tab on the lens
adapter.
4.Rotate the lens adapter counterclockwise
to release.
For Micro Four-Thirds (MFT) cameras, enable the “Shoot without Lens” function in the menu of the camera.
ONE-YEAR LIMITED WARRANTY
This VELLO product is warranted to the original purchaser to be free from defects in materials and workmanship
under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after
replacement, whichever occurs later. The warranty provider’s responsibility with respect to this limited warranty
shall be limited solely to repair or replacement, at the provider’s discretion, of any product that fails during normal use of this product in its intended manner and in its intended environment. Inoperability of the product or
part(s) shall be determined by the warranty provider. If the product has been discontinued, the warranty provider
reserves the right to replace it with a model of equivalent quality and function.
This warranty does not cover damage or defect caused by misuse, neglect, accident, alteration, abuse, improper
installation or maintenance. EXCEPT AS PROVIDED HEREIN, THE WARRANTY PROVIDER MAKES NEITHER
ANY EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This warranty
provides you with specific legal rights, and you may also have additional rights that vary from state to state.
To obtain warranty coverage, contact the Vello Customer Service Department to obtain a return merchandise
authorization (“RMA”) number, and return the defective product to Vello along with the RMA number and proof
of purchase. Shipment of the defective product is at the purchaser’s own risk and expense.
For more information or to arrange service, visit www.vellogear.com or call Customer Service at 212-594-2353.
Product warranty provided by the Gradus Group.
www.gradusgroup.com
VELLO is a registered trademark of the Gradus Group.
© 2014 Gradus Group LLC. All Rights Reserved.
www.vellogear.com
© Copyright 2014 Gradus Group
Vello and other names of Vello products are trademarks of Gradus Group. Other product and corporate names mentioned
herein are trademarks of their respective holders.
GG2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising