Wireless Setup - University of Maryland, Baltimore

Wireless Setup - University of Maryland, Baltimore
Wireless Setup
Windows Mobile 6.x
Configuring eduroam - Windows Mobile 6.x touch-phone devices
Configuration steps
This describes the configuration on Windows Mobile devices running Windows Mobile
6.x.
Make sure that you have your credentials ready and setup
•
Select Start then Settings then Connections then Wireless LAN then Turn on
Wireless LAN
•
On the Wireless LAN Main tab select Change Network
•
From the list of available networks choose eduroam
•
Your device will ask you to configure the Wireless Network
o
Check Network name is eduroam
o
Set Connects to to The Internet
then select Next
•
On the first Configure Network Authentication page
o
Set Authentication to WPA2
o
Set Data Encryption to AES
then select Next
•
•
•
On the next Configure Network Authentication page
o
set EAP type to PEAP
(MSCHAPv2)
then select Finish
The device will then try to connect to the eduroam network. At the User Logon page
o
enter your [email protected]
For example: [email protected]
o
enter your UMID password
After a few moments, your device should report that it is connected to the eduroam
service.
University of Maryland Baltimore Help Section
CITS IT Help Desk
Email:
Phone:
Fax:
Address:
Room:
[email protected]
410-706-HELP(4357)
410-706-4191
601 W. Lombard Street, Baltimore, MD 21201
5 Floor, Suite 540
th
Hours
Mon-Fri
Sat-Sun
8:00 am – 5:00 pm
8:00 am – 5:00 pm (Phone and E-Mail Only)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement