A 6 mm or 1/4” grade 5 (minimum) self-tapping screw is

A 6 mm or 1/4” grade 5 (minimum) self-tapping screw is
A 6 mm or 1/4” grade 5 (minimum) self-tapping screw is recommended to mount the ECU
to the bracket. The screw must have a protective coating that is electrically conductive. This
will assure a good electrical ground for the ECU. As an alternate fastener, use a 6 mm or
1/4” grade 5 bolt of sufficient length to reach through the ECU, bracket and trailer frame.
Remove any paint and contamination from the ECU bracket and trailer frame in the
area where the bolt, nut and washer will make contact to assure a good electrical
ground. If the ECU is not properly electrically grounded, ABS failure may result.
Step 10: Complete the installation and test the ABS according to the instructions in
Haldex ABS Installation Manual Number L30030.
Haldex Commercial Vehicle Systems
6/04 2.5M ART L31219
North American Sales Division
Haldex Brake Products Corporation
10707 N.W. Airworld Drive
Kansas City, MO 64153-1215
Phone: (816) 891-2470
Fax: (816) 801-4198
North American Sales Division
Haldex Limited
525 Southgate Drive, Unit 1
Guelph, Ontario CANADA N1G 3W6
Phone: (519) 826-7723
Fax: (519) 826-9497
www.haldex.com - www.hbsna.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement