5019 312 10149 AWT 5108/4 GB
GB
AWT 5108/4
A.
B.
C.
D.
Programme Selection Knob
Temperature Selection Knob
“Spin Speed Selection” Knob
“On/Off” Button
Cold
❉ : option / Yes: dosing required
1)
2)
3)
A
Programme
Care
Labels
B
C D
Type of wash / Notes
Do not use liquid detergents.
For improved garment care, spin speed is restricted to
800 rpm in this programme.
For improved garment care spin speed is null in this
programme.
Detergents and additives
Special Options
TemperaMax.
ture
load Prewash Main Softener Bleach Rapid Half Intensive Rinse
Wash
Load
Rinse Hold
Max.
Spin
Speed
°C
rpm
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
5.0
Yes
1)
Yes
❉
❉
❉
❉
❉
❉
Max. 90
1000
Synthetic with prewash
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
2.0
Yes
1)
Yes
❉
—
❉
❉
❉
❉
Max. 60
800 2)
Delicate with prewash
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
1.5
Yes 1)
Yes
❉
—
—
—
—
❉
Max. 40
800
Cotton
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
5.0
—
Yes
❉
❉
❉
❉
❉
❉
Max. 90
1000
Coloured Cotton
Normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and linen.
3.0
—
Yes
❉
—
—
❉
❉
❉
Max. 60
1000
kg
Cotton with prewash
2)
Slightly to normally soiled textiles made of cotton and/or synthetics.
3.0
—
Yes
❉
—
—
—
❉
❉
Max. 60
1000
Mixed cotton/
Synthetic
Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
2.0
—
Yes
❉
—
—
❉
❉
❉
Max. 60
800
2)
Synthetic
Normally soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.
1.5
—
Yes
❉
—
❉
❉
❉
❉
Max. 60
800
2)
Delicate
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
1.5
—
Yes
❉
—
—
—
—
❉
Max. 40
800
2)
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long.
1.0
—
Yes
❉
—
—
—
—
❉
Max. 40
800
2)
1.0
—
Yes
❉
—
—
—
—
❉
Max. 30
— 3)
Daily Mixed
Wool
Handwash
Rinse + Gentle Spin
—
Programme for treating delicate laundry with starch or softener.
2.0
—
—
❉
—
—
—
—
❉
—
800
Rinse + Spin
—
Programme for treating cotton or linen laundry with starch or softener.
5.0
—
—
❉
—
—
—
—
❉
—
1000
Spin
—
Programme to spin cotton or linen laundry intensively with maximum spin speed.
5.0
—
—
—
—
—
—
—
—
—
1000
Gentle spin
—
Programme to spin delicate laundry gently with a restricted spin speed.
2.0
—
—
—
—
—
—
—
—
—
800
Drain
—
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
—
—
—
—
—
—
—
—
—
—
—
2)
2)
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10149
CONSUMPTION DATA
Temperature Selector
Load
Water
Energy
(°C)
(kg)
(l)
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton
90
5.0
63*
1.80
2:05
Cotton
60
5.0
59
0.95
2:05
Cotton
40
5.0
59
0.60
2:05
Programme
Daily Mixed
40
3.0
45
0.48
1:00
Synthetic
60
2.0
62
0.80
1:35
Synthetic
40
2.0
56
0.45
1:30
Delicate
40
1.5
63
0.45
0:50
Wool
40
1.0
63
0.45
0:40
Handwash
30
1.0
63
0.30
0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the
water out.
PREPARATION OF WASH CYCLE
SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the “MAX” level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the programme selector knob to the
desired programme.
4. Turn the temperature selector knob to the
desired temperature.
5. Turn the spin speed selector knob to the
desired spin speed. If the spin speed “0” is
selected, the final spin is cancelled, but not the
intermediate spins. The programme ends with a
drain cycle.
Selecting or deselecting an option can be done at
any time during the programme. The option will
be applied as long as the corresponding
programme phase has not been executed yet.
“Rapid” button
• For fast, energy saving wash cycles.
• Ideally suited for small loads consisting of lightly
soiled laundry.
“Half Load” button
• Can be used for small loads and lightly soiled
laundry.
• Reduces the water consumption especially during
the rinses.
“Intensive Rinse” button
• One rinse cycle is added to ensure a more
intensive rinse.
• This option is particularly suitable for areas with
very soft water, washing baby linen and people
with detergents allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic”, “Delicate” and “Daily Mixed”
programmes.
• This function is particularly useful if you want
to postpone spinning to a later time, or if you
want to drain only.
Note: the programme selector knob stops on
.
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
programme will terminate automatically with
the selected spin cycle.
• If you do not wish to spin the clothes, press the
“On/Off” button, turn the programme selector
knob to the “Drain” programme and press the
“On/Off” button again.
PROGRAMME START
Turn on the tap and press the “On/Off” button.
The indicator light of the “On/Off” button lights
up.
Note: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop
position.
1. Press the “On/Off” button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drum doors and unload
the machine.
CHANGE THE PROGRAMME DURING THE WASH
CYCLE
1. Switch off the machine by pressing the
“On/Off” button.
2. Select the new programme.
3. Start programme by pressing the “On/Off”
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the “On/Off” button.
2. After the desired pause, press again the
“On/Off” button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
“On/Off” button.
2. Set the programme selector to “Drain”.
3. Press the “On/Off” button again to start the
“Drain” programme.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10149
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising