514039 Lalaloopsy RC Scooter 1-4

514039 Lalaloopsy RC Scooter 1-4
FCC COMPLIANCE
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) this device must accept any interference received, including interference that may cause undesired operation.
Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user‛s authority to operate the equipment.
CONTENTS
a) 1 Lalaloopsy™ RC Scooter
b) 1 Remote Control
c) 1 Removeable Popcorn Basket
SAFE BATTERY USAGE
• Use alkaline batteries for best performance and longer life.
• Use only the type battery recommended for the unit.
• Batteries should be replaced only by an adult.
• Insert batteries with the correct polarity ( + and – ).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable(nickel-cadmium) batteries.
• Do not short-circuit batteries.
• When not used for an extended time, remove batteries to prevent possible leakage and damage to the unit.
• Do not mix rechargeable and non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only under adult supervision.
• Do not recharge non-rechargeable batteries.
• Exhausted batteries are to be removed from the toy.
• Do not dispose of batteries in fire as they may leak or explode.
Age 4+ years
Adult Battery Installation Required
Item No. 516767 – 27 MHz
Item No. 516774 – 49 MHz
A.
C.
B.
Lalaloopsy™ Video
If you have a Mobile Barcode reader application
for your smartphone, scan this code to watch a
Lalaloopsy™ video or go online at
http://www.lalaloopsy.com/rcscooterqr
Internet connection required.
Ask your parents for permission to go online.
Data rates may apply.
‘Let‛s care for the environment!‛ The wheelie bin symbol indicates that the product must not be disposed of with other
household waste. Please use designated collection points or recycling facilities when disposing of the item. Do not
treat old batteries as household waste. Take them to a designated recycling facility.
Please keep this manual as it contains important information.
0212-0-E
4
© MGA Entertainment, Inc.
LALALOOPSY™, MINI LALALOOPSY™ and
LALALOOPSY LITTLES™ are trademarks of MGA in the
U.S. and other countries. All logos, names, characters,
likenesses, images, slogans, and packaging appearance
are the property of MGA.
16300 Roscoe Blvd.
Van Nuys, CA 91406 U.S.A.
(800) 222-4685
Printed in China
Illustrations are for reference only. Styles may vary from actual contents.
BATTERY INSTALLATION
SCOOTER
An ADULT must install batteries in the
Scooter.
Here‛s how:
1. Slide the ON/OFF/NO SOUND switch
to “OFF.”
2. Using a Phillips screwdriver (not
included), remove the screw and battery
compartment cover located on the
bottom of the Scooter. (Fig. 1)
3. Install four (4) AA alkaline batteries
(not included) making sure the (+) and (-)
ends face the proper direction as
indicated inside the battery compartment.
4. Replace the compartment cover and
tighten the screw.
1.5V AA / LR6
1.5V AA / LR6
1.5V AA / LR6
1.5V AA / LR6
ON / OFF / NO SOUND
Fig. 1
1
BATTERY INSTALLATION CONT‛D
OPERATING THE SCOOTER CONT‛D
1.5V AAA/LR03
ON
OFF
1.5V AAA/LR03
REMOTE CONTROL
An ADULT must install batteries in the Remote
Control. Here‛s how:
1. Switch the ON/OFF switch to “OFF.”
2. Using a Phillips screwdriver (not included)
remove the screw and battery compartment
cover on the back of the Remote Control.
(Fig. 2)
3. Install two (2) AAA alkaline batteries
(not included) making sure the (+) and (-)
ends face the proper direction as indicated
inside the battery compartment. (Fig. 2)
4. Replace the compartment cover and tighten
the screw.
5. Use the Remote Control to drive your Scooter by doing the following:
a. Press down on the left side of the Remote Control to go forward. (Fig. 5)
b. Press down the right side of the Remote Control to back up and turn to the
left. (Fig. 6)
Fig. 2
SEAT BELTS
Fig. 7
FUN NOTE: Watch her pop a wheelie when she first takes off! (Fig. 7) Then the front wheel
will touch down and the Scooter will continue moving forward.
Large-sized Lalaloopsy™ Doll must be secured onto Scooter in order to pop a wheelie.
Scooter will not pop a wheelie on its own.
Elastic
Band
Fig. 3
Fig. 4
1. Remove pegs on Seat Belt from the openings on the seat. (Fig. 3)
2. Place the large Lalaloopsy™ Doll in the seat, place Seat Belt pegs in openings and press down.
3. Lift the elastic band on the back of the doll‛s seat. Place toy pet under elastic band. (Fig. 4)
OPERATING THE SCOOTER
IMPORTANT INFORMATION
• Scooter will function properly with all REGULAR large Lalaloopsy™ Dolls. Lalaloopsy‛s with Silly Hair™ or
other special features will cause the scooter to tip over.
• When driving two RC Scooters, they must be of different radio frequencies (e.g. one Scooter 49MHz and
one Scooter 27MHz) or they may not perform as designed.
• When Scooter is not being played with, turn the ON/OFF/NO SOUND switches on both the Scooter and
Remote Control to “OFF” to save battery power.
• Your Scooter is controlled by radio frequency. It may interfere with nearby devices such as cordless
phones, hair dryers, radios, walkie-talkies, or other radio controlled devices. If this occurs, move the
Scooter to a location away from the interference.
• The Scooter must remain in remote control range to operate correctly. The range depends on the
surrounding area and on the strength of the battery. Obstructions such as buildings, fences, etc., between
the remote control transmitter and the Scooter reduce the range.
• If the Scooter runs slowly, replace the batteries.
• KEEP AWAY FROM WATER! Do not run your Scooter through puddles, or expose it to liquid of any kind as
moisture may damage the unit.
CAUTION:
Fig. 5
2
Fig. 6
1. Slide the ON/OFF/NO SOUND switch on the bottom of the Scooter to the “ON” position.
2. Slide the ON/OFF switch on the back of the Remote Control to the “ON” position.
3. Place the Scooter on a flat, level surface.
NOTE: Scooter‛s performance may vary depending on flooring.
4. Straighten the Antenna.
NOTE: If you wish to drive the Scooter with no sound, slide the ON/OFF/NO SOUND switch
located at the bottom of the Scooter all the way to the right. (Fig. 1)
• DO NOT sit or stand on any part of the Scooter.
• DO NOT lift and/or drop the Scooter as doing so may cause bodily injury to the user and irreparable
damage to the Scooter.
• Play with the Scooter on the floor or ground only.
• DO NOT operate this Scooter during thunderstorms.
• Keep hair, fingers, loose clothing and other items away from rotating wheels of the unit.
• DO NOT play with this toy in the street or other places where cars are driven.
TROUBLESHOOTING:
IF THERE IS NO FUNCTION BETWEEN THE REMOTE CONTROL AND THE SCOOTER:
• Make sure the Remote Control and the Scooter switches are in the “ON” position.
• Make sure the batteries are inserted properly.
• Replace the old batteries with new alkaline batteries.
• Move the Remote Control closer to the Scooter to determine the best communication between
the two.
3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising