Fitting Instructions BTF77

Fitting Instructions
BTF77
PO Box 5666, Minto, NSW, 2566 Australia
Ph: 61 2 9603 0111 Fax: 61 2 9820 2500
E-mail: [email protected]
A.B.N. 68 073 002 034
Application;
Toyota Corolla AE92-93 1989-1994 FRONT
(without OEM front sway bar).
(Refer catalogue for exact listing).
Specification;
BTF77 - 24mm non-adjustable full kit sway bar.
Code: Z254
Sway bar
Washer-large
Bolt
Nyloc nut
Washer-small
Link
Washer (saucer)
Lock nuts
Chassis/
suspension
mount
Nyloc nut
Contents;
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
2 x D-bush
4 x link bush
2 x 3/8 * 2 inch bolt
4 x 3/8 * 1 inch bolt
2 x M10 nyloc nut
4 x M10 nut
4 x 3/8 nyloc nut
2 x 3/8 * 1 1/4 flat washer large
4 x M10 saucer washer
6 x 3/8 * 7/8 flat washer small
4 x M10 spring washer
2 x chassis bracket
1 x grease bag
2 x single eye link
2 x D-bush bracket
1 x sway bar
CHASSIS MOUNT
SWAY BAR
CONTROL ARM
LINK
PICTURE 1
SWAY BAR
Fitting:
CHASSIS MOUNT
Sway bar installation must be done with the vehicle at normal ride
height. Check fitting kit contents before installation.
1. Attach sway bar chassis brackets at the rear of the control arm.
2. Loosely attach sway bar links to the control arms through
original mounting holes.
CONTROL ARM
3. Lubricate bushes with grease supplied and fit to the sway bar.
4. Mount sway bar onto chassis brackets.
PICTURE 2
5. Loosely attach sway bar links to the sway bar, with the links
located on the outside of the sway bar.
CHASSIS MOUNT
6. With the sway bar in its correct position, tighten all fasteners.
7. Test drive the vehicle, and re-check tension.
CONTROL ARM
LINK
SWAY BAR
PICTURE 3
Warning: Please drive carefully while you accustom yourself to the changed vehicle behaviour.

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project