Secure Motorcycle Parking Kiosk Receipt Holder

Secure Motorcycle Parking Kiosk Receipt Holder
Secure Motorcycle Parking Kiosk Receipt Holder
Below is a simple secure holder that can be made from simple hardware items. $4.00 plus a lock.
Screw Eye – ¼” x 6”
PVC glued Cap 1¼”
Clear Tubing 1 5/8” OD 4 inches long
Washer & Nut ¼ “
PVC Threaded Cap 1¼
Lock
Drill a 17/64th hole in the center of each cap.
Temporarily screw the screw eye into the end cap locking it with two nuts.
Cut ½ “ off of the open end of each PVC cap. Use the screw eye as a handle. There is no need to have the caps
engage so deep. It will make it difficult to remove old receipts.
Remove the screw eye and install onto the threaded cap with the washer & nut on the outside.
Leave 1/8” of thread exposed on the nut.
Peen (hammer) over the exposed thread to prevent the nut from being removed.
Drill two more 17/64” holes on either side of the glued cap hole.
Use your drill to wipe across all three holes to make a slot that will fit the eye of the Screw eye.
You can hammer or vice the width of the screw eye so the slot can be shorter.
Assemble it all as shown in the pictures below.
Use a hasp lock to loop between a brake/clutch cable and the holder
It cannot be disassembled without removing the lock
Version 1 16 Apr 2015
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement