KHX1600C9D3P1K2/8G - Australia Computer Online

KHX1600C9D3P1K2/8G - Australia Computer Online
KHX1600C9D3P1K2/8G
8GB (4GB 512M x 64-Bit x 2 pcs.)
DDR3-1600MHz CL9 240-Pin DIMM Kit
Supports Kingston HyperX Plug and Play (PnP)
FEATURES:
•
•
•
•
•
•
•
•
•
•
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10,11
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1
clock
Programmable CAS Write Latency(CWL) = 8(DDR31600)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential
with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either
on the fly using A12 or MRS]
•
•
DESCRIPTION:
Kingston's KHX1600C9D3P1K2/8G is a kit of two 512M
x 64-bit (4GB) DDR3-1600 CL9 SDRAM (Synchronous
DRAM) memory modules, based on sixteen 256M x 8-bit
•
•
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration
through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE
85°C, 3.9us at 85°C < TCASE < 95°C
•
•
Asynchronous Reset
PCB : Height 1.18” (30.00mm) double sided
JEDEC DDR3-1600 at a low latency timing of 9-9-9 at
1.5V. Additional timing parameters are shown in the
•
component
RoHS Compliant
PnP Timing Parameters section. Each 240-pin DIMM
uses gold contact fingers and requires +1.5V. The
PERFORMANCE:
DDR3 FBGA components per module. Total kit capacity
is 8GB. Each module kit has been tested to run at
electrical and mechanical specifications are as follows:
Note: PnP implementation is only possible in configurations that include a BIOS that supports the PnP function. Your maximum speed will be determined by your
BIOS.
•
•
•
•
•
•
•
•
CL(IDD): 9 cycles
Row Cycle Time (tRCmin): 48.125ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin): 160ns
Row Active Time (tRASmin): 33.75ns (min.)
Power: TBD (operating per module)
UL Rating: 94 V - 0
Operating Temperature: 0o C to 85o C
Storage Temperature: -55o C to +100o C
PnP JEDEC TIMING PARAMETERS:
•
•
•
DDR3-1600 CL9-9-9 @1.5V
DDR3-1333 CL8-8-8 @1.5V
DDR3-1066 CL6-6-6 @1.5V
Document No. 4806050-001.A00
04/21/11
Page 1
MODULE DIMENSIONS:
T E C H N O L O G Y
133.35
Units: millimeters
30.00
18.80
15.80
11.00
8.00
54.70
0.00
0.00
MODULE WITH HEAT SPREADER:
Document No. 4806050-001.A00
Page 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement