Suction Cups Power Lock® Suction Cups

Suction Cups
How to Apply Traditional Suction Cups.
1. Suction cups can be applied to most smooth, non-porous surfaces.
2. Clean the mounting surface with a mild detergent. Rinse well to remove all soap
and debris.
3. Use a mild detergent with water to clean the suction cup. Rinse well to remove all
soap and debris. Do not use an abrasive soap as it may create scratches on the
suction cup, preventing it from sticking to the mounting surface.
4. Shake off excess water from the suction cup and firmly press it against the
mounting surface until it is flat.
How to Remove a Traditional Suction Cup.
1. Some suction cups may have a small pull tab located along its perimeter. If so,
pull this tab to release it from the mounting surface.
2. If the suction cup does not have a pull tab as noted above, you will need to gently
pry up the edge of the suction cup to release the vacuum and detach it from the
mounting surface.
Power Lock® Suction Cups
How to apply Power Lock® Suction Cups.
1. Suction cups can be applied to most smooth, non-porous surfaces.
2. Clean the mounting surface with a mild detergent. Rinse well to remove all soap
and debris.
3. Use a mild detergent with water to clean the suction cup. Rinse well to remove all
soap and debris. Do not use an abrasive soap as it may cause scratches on the
suction cup, preventing it from sticking to the mating surface.
4. Shake off excess water from the suction cup.
5. Rotate the hook attached to the suction cup upward until it stops. Place the
suction cup on the mounting surface and firmly press it against the mounting
surface until it is flat. Now flip the hook downward into its locking position.
How to Remove a Power Lock® Suction Cup.
1. Flip the hook upward to unlock, then pry the edge of the suction cup up to
release the vacuum and detach it from the mounting surface.
Revised: March 2017