Locker Desk
PARTS INCLUDED:
A- Front Locking Casters (2pcs)
B- Rear Casters (2pcs)
TOOLS INCLUDED:
C- Open-end Wrench (1pc)
ASSEMBLY INSTRUCTIONS:
1. Turn the desk upside down on a soft, scratch-free surface, as shown.
2. Using the Open-end Wrench (C), screw the Front Locking Casters (A) to the front desk legs.
3. Using the Open-end Wrench (C), screw the Rear Casters (B) to the rear desk legs.
A
B
A
Please Note:
Keyboard tray is preassembled with
bottom mount full
extension drawer
glides
C
1/4
www.pbteen.com
Locker Drawer
HARDWARE INCLUDED:
A- Screw (2pcs)
B- Washer (4pcs)
C- Handler (1pc)
TOOLS REQUIRED (but not included):
• Phillips Head Screwdriver
HANDLE INSTALLATION:
1. The Handle (C) is pre-assembled on the interior of the drawer. Use a Phillips Head Screwdriver to unscrew
and remove the Handle (C) and Washers (B) from drawer.
2. Place a Screw (A) through a Washer (B) and insert into the pre-drilled holes on the interior of the drawer.
Repeat for each pre-drilled hole.
3. As the Screw (A) exits the drawer front, place another Washer (B) on the end of the Screw (A), for each
pre-drilled hole. Align the Handle (C) to the Screws (A). Tighten the Screws (A) and Washers (B) into
Handle (C) with a Phillips Head Screwdriver until it is firmly attached to drawer.
2/4
www.pbteen.com
DRAWER INSTALLATION:
Please Note: Improperly inserting the drawer into the extended glides may damage the glides! Hold the drawer at a
level position and carefully align each side of drawer glide while inserting it into the case glides on the furniture
piece.
1. Reach inside the case piece and ensure that the inner glide is in the forward position. If it is not in the proper
position, push the inner glide forward manually. A screwdriver or other tool may be required. See Figure
Figure 1
If it is not in the proper position,
push the inner glide forward manually.
A screwdriver or other tool may be required.
Ensure that the inner glide
is in the forward position.
2. Make sure the leaf spring on both sides of the drawer glides is pushed in and hold it so that it aligns with
the extended inner glides of the furniture piece. At a level position, carefully insert the drawer into the
case piece. Align the back end of the drawer so that the glides on either side of the drawer line up with the
glides on either side of the opening of the case. Insert the drawer into the case continuing to make sure
the drawer glides are properly aligned with the glides of the case. Please Note: Continue to hold the leaf
springs at both sides until the drawer is properly inserted into the case piece. See Figure 2.
Figure 2
Push in and hold both sides of
leaf spring during installation.
Leaf Spring
3. Close the drawer (there will be some resistance; push slowly and firmly) and push the drawer
completely in.
3/4
www.pbteen.com
DRAWER REMOVAL:
1. Push in the leaf spring (located at the arrow point in Figure 3) on the both sides of drawer glides. See
Figure 3. While holding the leaf springs in, slowly pull the drawer out at level position, as shown in
Figure 4.
Figure 3
Figure 4
Leaf Spring
CARE INSTRUCTIONS:
• Dust often using a soft, lint free cloth. A damp cloth may be used.
• Dry thoroughly.
• Furniture polishes and household cleaners are not recommended.
4/4
www.pbteen.com