no-zip double pet stroller

For The ON-THE-GO Pet™
INSTRUCTION MANUAL
NO-ZIP DOUBLE PET STROLLER
PG8700NZ
Interior Dimensions:
27"L x 20"W x 23"H
To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
customerservice@petgearinc.com
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
PARTS LIST
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service.
Axle
Air Pump
Stroller
1-Front Double
Wheel
Cup Holder
2-Back Wheels
Weather Cover
UNFOLDING THE STROLLER
Step 1. Release folding latch (A).
B.
tep 2. Spread handle (B) and seat
S
apart until the frame clicks and locks
on both sides.
Step 3. Ensure that the stroller is
locked in on both sides before using.
2
A.
NO-ZIP DOUBLE PET STROLLER • PG8700NZ
OPENING THE STROLLER
Spread the canopy apart to the open position.
Apply brake lever by pushing down with toe.
Ensure brakes are applied when parking stroller.
Canopy
Release by lifting brake lever with toe.
WARNING: Never leave your stroller parked
without applying brakes.
Back View of Stroller
Step Here
BACK WHEEL ASSEMBLY INSTRUCTIONS
Push back wheels until they easily click into place.
Shown with both back wheels in place.
NO-ZIP DOUBLE PET STROLLER • PG8700NZ
3
BACK WHEEL ASSEMBLY INSTRUCTIONS
To connect or release wheels
from axle, squeeze pin in.
Pin
FRONT WHEEL ASSEMBLY INSTRUCTIONS
Step 1. To attach front wheels, slide plastic wheel
supports up and into tubing.
Step 2. Slide wheels up, until velco pins pop out
of holes.
Tubing
Velco
Pin
Tubing
Slide wheels up
4
NO-ZIP DOUBLE PET STROLLER • PG8700NZ
FRONT WHEEL ASSEMBLY INSTRUCTIONS
Step 3. To use stroller in locked position for jogging,
push pin in.
Locked
Position
Step 4. To use stroller in swivel position, pull pin
down, and to the right.
Swivel
Position
PUMP INSTRUCTIONS
Step 1. Pull stem out from inside of the pump.
Step 4. Remove cap on valve, then place stem onto
valve and pump tire with handle.
After tire is filled, place cap back onto valve.
Step 2. Place inside opposite end.
Cap/Valve
Handle Pump
Step 3. Twist on until tight.
Stem
NO-ZIP DOUBLE PET STROLLER • PG8700NZ
5
TO SECURE COMPARTMENT TO FRAME
Step 1. Open stroller and pull
compartment down.
Step 2. Clip onto frame.
TO SECURE LATCH
Step 1. To close compartment, pull
downward to latch clip onto frame.
Step 2. Lift up on latch clip and secure
by pushing down until it locks.
6
NO-ZIP DOUBLE PET STROLLER • PG8700NZ
TO UNLOCK LATCH
Pull upward on latch clip to release.
TO SECURE SIDE FLAP
To help secure compartment, Velcro flap around
tube and fasten to the bottom of the compartment.
NO-ZIP DOUBLE PET STROLLER • PG8700NZ
7
FOLDING THE STROLLER
Step 1. NOTE: Before folding the stroller,
unclip steel latch, and open the canopy.
Step 2. Slide second frame lock release (C)
to the right, while squeezing the main frame
lock release (D) rotate the folding mechanism
almost 180 degrees forward until stroller
releases and handle is lowered.
C.
SLIDE FRAME
LOCK RELEASE
TO RIGHT
SLIDE FRAME
LOCK RELEASE
TO RIGHT
SLIDE FRAME
LOCK RELEASE
TO RIGHT
C.
C.
D.
SQUEEZE MAIN FRAME
LOCK RELEASE AND
ROTATE
D.
SQUEEZE MAIN FRAME
LOCK RELEASE AND
ROTATE
ROTATE 180 DEGREES FORWARD WHILE
SQUEEZING MAIN FRAME (D) LOCK RELEASE
8
NO-ZIP DOUBLE PET STROLLER • PG8700NZ
CUP HOLDER INSTRUCTIONS
There is a rivet
on the side of the
stroller handle.
SLIDE CUP HOLDER
DOWN, ONTO RIVET
To attach cup
holder, slide it down,
onto the rivet.
RIVET
RIVET
LOOKING AFTER YOUR STROLLER
• Always store product in a clean, dry place.
• Not recommended for use on the beach.
• Do not put heavy items on top of the stroller.
• Clean frame by wiping with a lightly oiled cloth.
• Do not use detergent or abrasives. Spot clean fabric with dry cleaning fluid or mild soap
and warm water.
• To ensure easy maneuverability and to minimize wear and tear, (especially wheels, axles,
and swivels), keep all moving parts clean and lubricated with WD40® or light machine oil.
• NOTE: Do not lubricate brake components or swivel locks.
• Regularly check stroller for loose parts. These should be tightened or replaced.
WHEEL MAINTENANCE
• To clean and lubricate front and rear wheels, push out locking lever under wheel housing
to release rear wheel.
• To ensure ease of maneuverability and to minimize wear and tear, keep all moving parts
clean and lubricated with WD40® or light machine oil.
• Push wheel sets back on until they click and lock in position; pull on wheel housings to
ensure they are secure.
• Push stroller back and forth and rotate swivels around to work in lubricant.
• Clean the rear wheel assembly and the rest of the frame with warm, soapy water; clean
off with warm water and dry thoroughly.
• NOTE: Do not lubricate brake components or swivel locks.
NO-ZIP DOUBLE PET STROLLER • PG8700NZ
9
WARNING!
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw
aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive,
destructive, immature or untrained animals. Do not use near an open or exposed flame. Failure to follow these
warnings and the instructions could result in serious injury or death.
• Do not carry additional bags, goods, or accessories in or on stroller except as recommended
in the manufacturer’s instructions.
• Recommended use of an approved safety restraint correctly fitted and adjusted.
• Do not leave pet unsupervised in stroller.
• Before making adjustments to stroller ensure that pet’s body is clear of any moving parts.
• This stroller is designed for one pet only.
• Do not hang bags from handles as this may cause the product to become unstable.
• Do not use on escalator or stairs; fold stroller and carry.
• Put on brake whenever you park the stroller.
• Ensure stroller is completely erected and check that all locks are engaged before placing pet
in stroller.
• Do not overload as stroller may become unstable; maximum weight of pet using this stroller
not to exceed 90 lbs.
• Any goods carried in the basket not to exceed 6 lbs.
REPLACEMENT PARTS
Use only PET GEAR replacement parts.
Please have your model number ready before calling.
You can also request parts: http://www.petgearinc.com/main.asp?sel=2
192 Sheldon Avenue • West Rutland, VT 05777 • 877-752-9123 • www.petgearinc.com
10
NO-ZIP DOUBLE PET STROLLER • PG8700NZ