INSTALLATION INSTRUCTIONS FOR UNDERMOUNT SINK

INSTALLATION INSTRUCTIONS
FOR UNDERMOUNT SINK
Please carefully read complete instructions before beginning installation. Note: These instructions are for installations with solid surfaces, composite
material countertops. Stylish Sinks recommends professional countertop installers and is not responsible for damage to the countertop or sink during
installation
1. Unpack the new sink and check the contents of materials supplied: Sink, mounting brackets, strainer and cut-out template (depending on
model)
2. Supplied cut-out template provides follow options of installation:
A.Flush mount: Sink edge is flush with countertop opening (FIGURE 1)
3. Cut-out the appropriate template for your sink model and desired installation option. Place template in desired position on countertop locating
center of the bowl over cabinet and faucet holes
4. Trace the outline of the template and cut countertop according to templated outline using appropriate cutting tools. Template is for guide only.
Use physical sink to ensure accurate cut-out opening (FIGURE 2)
5. Locate the drill holes on the underside of the countertop, approximately 1” from edge of the sink to be installed. Holes should be evenly spaced
approximately 6” to 8” apart starting from every corner as shown in (FIGURE 3). It is recommended to install a faucet at this point before installing
the sink
FIGURE 1
FIGURE 2
FIGURE 3
6. Loosely attach mounting brackets to the countertop, parallel to the cut-out opening using the supplied mounting screws and nuts. Mounting
screws with brass inserts are supplied with the sink, however, countertop material vary and the correct type of fasteners should be
recommended by your installer or supplier
7. Clean sink flange and underside of cut-out area of countertop, making sure that the area is smooth and free of grease. Apply continuous bead
of silicone caulk evenly on top of sink flange (FIGURE 4)
8. Position and align sink over the countertop opening and press sink onto countertop. Turn bent end of mounting bracket to snug over the sink rim
(FIGURE 5)
9. Check alignment of sink again and tighten fasteners to secure sink
10. Wipe away excess silicone caulk with damp cloth. Connect drain and water supply according to manufacturer’s instruction (FIGURE 6)
1. Basket
2. Metal Strainer
FIGURE 4
3. Screw
4. Rubber seal
5. Rubber gasket
FIGURE 5
6. Main body
FIGURE 6