Engineering Excellence
Engineering E xcellence
Installation Guide
Two Handle Kitchen Faucet:
• 2AM400
• 2AM401
This product meets the following standards:
•
•
•
•
•
ASME A112.18.1
ANSI A117.1
ANSI / NSF 61, SECTION 9
CUPC / IAPMO LISTED / ADA COMPLIANT
CONTAINS NO MORE THAN 0.25% WEIGHTED
AVERAGE LEAD CONTENT
Pioneer Industries, Inc. © 2012
Engineering Excellence
REV-10 31, 12
Thank you for purchasing this Pioneer quality product.
Tools Required
Adjustable
Wrench
Teflon Tape
Rags
Prior to Installation
• Observe all local plumbing and building codes before you begin
installation.
• Carefully shut off both hot and cold water supplies.
• Plug the sink drain with a soft cloth to prevent intrusion of debris or the
loss of any parts.
• Pioneer reserves the right to make changes in the design of faucets
without notice.
2
REV-10 31, 12
Faucet Installation
•
1.
2.
3.
4.
5.
Note:- The faucet escutcheon (A) is supplied with rubber gasket to form
watertight seal. Do not use rubber gasket and plumbers putty both to
form watertight seal.
Place escutcheon (A) underneath of the faucet. Ensure to put rubber
gasket underneath of the escutcheon (A). Slide inlet flex hoses through
mounting hole.
Slide mounting washer (B) and mounting plate (C) through mounting
bolt.
Thread mounting nut(D) to the mounting bolt. Do not overtighten.
Apply plumbers putty underneath of the hose guide(E). Place the hose
guide(E) through mounting hole.
Thread the locknut(F) to the hose guide(E). Do not overtighten. Lead the
side spray hose(G) through hose guide (E). Connect side spray hose (G)
to the spray port from underneath of the sink.
3
REV-10 31, 12
Faucet Installation Drawing
4
REV-10 31, 12
Faucet Installation
6.
7.
8.
9.
Thread the side spray(H) to side spray hose(G).
Apply teflon tape to outlet of supply stop(J).
Use main supply line(I) to connect the main supply stop(J) (left is hot
water supplies and right is cold water supplies). Do not over tighten.
Remove the aerator(K) from the spout by turning counterclockwise.
Turn on main supply stops. Check of any leaks. Make sure all the connection are secure. Open both hot and cold handles. Flush and allow
water to run at full flow for at least one minute. Turn off water. Replace
aerator(K).
For more care information or trouble shooting inquiries about your
Pioneer Product, please see the contact information on the back page.
5
REV-10 31, 12
Engineering Excellence
Engineering E xcellence
3325 S. Garfield Ave. | Commerce, CA 90040
Telephone: (800) 338-9468 | (323) 888-8873 | Fax: (323) 888-9515
Hours: M - F, 7:30am to 5:00pm PST
www.pioneerind.com
REV-10 31, 12
6
Download PDF