Caffitaly CML-01, CML-02, CML-10 Milk Frother User manual
The Caffitaly Latte+ Milk Frother CML-01, CML-02 and CML-10 are designed for making warm or cold milk froth. This device can froth a minimum of 100 ml and a maximum of 150 ml of milk. It can also heat milk with a minimum capacity of 100 ml and a maximum capacity of 250 ml.
PDF
Download
Document
Advertisement
Advertisement
CAFFITALY LATTE+ MILK FROTHER CML-01 / CML-02 / CML-10 User manual | Caffitaly IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions. 2.Do not touch hot surfaces. Use handles or knobs. 3. To protect against fire, electric shock and injury to persons do not immerse cord, plugs, in water or other liquid. 4. Close supervision is necessary when any appliance is used by or | near children. 5. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance. 6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or adjustment. - 7. The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons. 8. Do not use outdoors. 9. Do not let cord hang over edge of table or counter, or touch hot surfaces. 10. Do not place on or near a hot gas or electric burner, or touch hot surfaces. 11. To disconnect, turn any control to “off”, then remove sita from wall outlet. 12. Do not use appliance for other than intended use. 13. Household use only. | 14, Do not immerse in water. 15. The lid must be closed when using milk frother. 16. Scalding may occur if the lid is removed during the brewing cycles. | 17. Save these instructions. IMPORTANT: The appliance has a touch key that can only be switched on; Disposal of the Old Device it switches off automatically. Old electric and electronic devices frequently still contain valuable materials. The instruction of power cord: However, they also contain damaging substances, which were necessary for their A short power-supply cord is to be provided to reduce risks resulting from à functionality and safety. becoming entangled In or tripping over a linger cord. If these were put in the non-recyclable waste or were handled incorrectly, they a) Longer detachable power-supply cords or extension cords are available and could be detrimental to human health and the environment. Therefore, do not put may be used if care is exercised in their use. your old device into the non-recyclable waste under any circumstances. b) If a long detachable power-supply cord or extension cord is used: * The marked electrical rating of the detachable power-supply cord | PLE ASE NOTE arexiensian coral shoule beat lnastas great es ie electrical raing of » Use the collection point, established in your town, to return and recycle old the appliance. ; | ; electric and electronic devices. If necessary, contact your town hall, НН e |f the appliance is of the grounded type, the extension cord should be A Intermation, agmunding type &-wira.cord; and май » Ensure that your old device is stored safely away from children until it is taken The longer cord should be arranged so that it will not drape over the away or replace it with a trouble-free device. countertop or table top where it can be pulled on by children or tripped over. RISK OF FIRE OR ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. | REPAIR MUST BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY. 1 Operating Manual 1.1 General Please read the information contained herein so that you can become familiar with your device quickly and take advantage of all its functions. 1.2 Information on this manual These instructions provide you with important information for the initial commissioning, safety, intended use and care of the device. The operating instructions must be available at all times to the user of the device and should be read before using the device. Keep the operating manual in a safe place and pass it on to the subsequent owner along with the device. 2 Safeties 2.1 Intended use This device is only intended for use in households in enclosed spaces for: e making milk foam and heating milk WARNING Danger due to unintended use! Dangers can emanate from the device if it is used for an unintended use and/or a different kind of use. » Use the device exclusively for its intended use. » Follow carefully the user instructions and procedures in thig manual. Claims of all kinds due to damages resulting from unintended uses are excluded. The user bears the sole risk. 2.2 General Safety information PLEASE NOTE Please observe the following general safety notices with regard to the safe handling of the device. » Examine the device for any visible external damages prior to using it. Never put a damaged device into operation. » This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. | » Keep the appliance and its cord out of reach of children less than 8 years. * » Do not leave the device unsupervised when it is in operation. » Only customer service departments authorized by the manufacturer may carry out repairs on the device during the guarantee period, as otherwise the guarantee entitlements will be null and void in the event of any subsequent damages. » Do not use other liquids than milk. 2.3 Danger of burns DANGER The heated milk in the milk frother and the interior of the jug can get very hot. » When the milk is heated, the interior of the jug gets very hot! » Always check the temperature of the milk, before drinking it. » When you are heating the milk, keep the lid closed. 2.4 Dangers due to electrical power DANGER Mortal danger due to electrical power! » If the connection lead is damaged, you will need to have a special connection lead installed by an authorized electrician. » Do not operate this device if its power cable or plug is damaged, if it does not work properly or if it is damaged or has been dropped. » Do not open the housing on the device under any circumstances. There Is a danger of an electrical shock if live connections are touched and the electrical or mechanical structure is altered. In addition, functional faults on the device can also occur. —lÑ | 3 Commissioning 3.1 Safety information Packaging materials may not be used for playing. There is a danger of suffocation. 3.2 Box content The milk frother is delivered with the following components: e Milk frother * Whisk for frothing e Operating Instructions PLEASE NOTE >» Immediately verify that you have all accessories and that the unit is not damaged. » Notify the seller or transporter in case of damage or incomplete assembly and missing accessories. 3.3 Unpacking e Take out the device from the box and remove the interior and exterior packaging. * Clean the appliance thoroughly before the first use (see chapter Cleaning and maintenance). 3.4 Setup location requirements * The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing capacity. * The device is not intended to be installed in a wall or a built<in cupboard. e Do not set up the device in a hot, wet or extremely damp environment or near fammable material. * The electrical socket must be easily accessible in the case of an emergency. * The installatlon and assembly of this device in non-stationary setup locations (e.g. cars, boats, RV) is to the sole responsibility of the user. 3.5 Electrical connection * Before connecting the device, compare the connection data (voltage and frequency) on the rating plate with those of your electrical network. * The electrical outlet must be protected by a 16A safety cut-out switch, * The connection between the device and the electrical network may employ a 3 meter long (max.) extension cable with a cross-section of 1.6 mm2 4 Functions In this chapter, you'll find important information on the function of the device. 4.1 Overview: 1 Lid 2 Whisk holder with magnetic whisk 3 Jug 4 Power button 5 Power base 4.2 Rating plate The rating plate with the connection and performance data can be founded beneath the device. 5 Operation and Handling This chapter provides you with important notices with regard to operating the — device. Observe the following notices to avoid dangers and damages: WARNING > Do not leave the device unsupervised when it is in operation, so that you can intervene quickly in the event of dangers. 5.1 Operation With the milk frother you can heat cold as well as warm milk froth. The appliance has got three markings for the filling: MIN: Fill milk at least up to that marking. T MAX FROTH: Fill milk up to that maximum marking to make milk froth (filling more can cause overflow when frothing). MAX MILK: When you want to heat milk but not froth it, you can fill milk up to that maximum marking. PLEASE NOTE » Please note the maximum froth markings. Please use for milk froth only the MAX FROTH marking. Otherwise so much foam will be made that the lid would lift and milk would overflow, You can make warm as well as cold milk froth. PLEASE NOTE » Please press the power button with your finger to determine the frothing/ heating mode you need. WARM MILK FROTH Please put the whisk for frothing into the whisk holder. Switch on the power button. The power button lights red. This is the setting for the warm milk froth. The appliance starts to make milk foam and stops automatically as soon as the foam is finished. HOT MILK Please put the whisk for frothing into the whisk holder. Press the power button twice, it blinks red, the milk is heated. The whisk rotates with reduced speed in order to ensure even heat distribution and prevent the milk from burning. COLD MILK FROTH Please put the whisk for frothing into the whisk holder. Switch on the appliance. Press the power button for approximately 2 seconds until it lights blue. Now cold milk froth is made. SETTINGS: Setting power button: | Result: Lights red Warm milk froth is made Blinks red Milk is heated Lights blue Cold milk froth is made PLEASE NOTE » Please pour out the milk and the milk froth. By using a metal spoon or another object with sharp edges you risk damaging the coating of the pot. » Only fill milk into the appliance. 6 Cleaning and Maintenance This chapter provides you with important notices with regard to cleaning and maintaining the device. Please observe the notices to prevent damages due to cleaning the device incorrectly and to ensure trouble-free operation. 6.1 Safety information ATTENTION Please observe the safety instructions, before cleaning your appliances. » Before cleaning, switch off the unit and take the power plug out of the outlet. » Clean the appliances with a soft cloth. » Don't clean the appliances with inflammable detergents. >» Clean the appliances again thoroughly when the machine hasn't been used for a long time. 6.2 Cleaning e Take off the lid and the whisk holder. You can remove the magnetic whisk from the side of its holder. e Clean the lid and the whisk as well as the jug of the milk frother with diluted detergent, with warm water and a soft sponge or a cloth. Rinse with cold or lukewarm water. 6 * Do not use any hard or sharp-edged objects or abrasive cleaning agents to clean the jug because the coating could be damaged. e Clean the outside of the appliance with a damp cloth. * Jug and basis are not suitable for dish washer. * Never immerse the appliance in water or other liquids. 7 Troubleshooting 7.1 Security advices ATTENTION >» Repairs of electrical appliances must be carried out by qualified personnel who are trained by the manufacturer, » Repairs performed by untrained persons may result in considerable hazards for the user and damage the machine. 7.2 Troubleshooting Error Possible cause Solution The appliance doesn't work. Mains plug is not connected correctly or carafe not inserted on power base. Make sure the unit is properly inserted on the power base and the power cord is correctly plugged in the power outlet. Electronic defect. Please contact customer support. ATTENTION > |f above mentioned steps don't solve the problem, please contact your customer service. PLEASE NOTE > Utilize the collection point, established in your town, to return and recycle old electric and electronic devices. If necessary, contact your town hall, local refuse collection service or your dealer for information. >» Ensure that your old device is stored safely away from children until it is taken away or replace it with a trouble-free device. 8 Technical Data Device Milk frother Name Caffitaly latte+ Model CML-01 (black) CML-02 (white) CML-10 (stainless steel) item No.: Mains data 120V, 60Hz Power consumption 500 W Capacity frothing Min: 100 ml, Max: 150 ml Capacity warming Min: 100 mi, Max: 250 ml External measurements (D x H x VW): Diameter: 11.8 cm Height: 19.5 cm Width with handle: 17.0 cm Net weight 0.865 kg (with power base) FOR ALL FURTHER QUESTIONS, COMMENTS OR TO OBTAIN TECHNICAL SUPPORT FOR YOUR CAFFITALY LATTE+ CML-01 / CML-02 / CML-10, PLEASE CONTACT US AT: LA) DATE OF PURCHASE: MANUFACTURED FOR: ellucci LES DISTRIBUTIONS LTEE 8145 Saint-Laurent Blvd., Montréal QC Canada H2P 2M1 1-877-819-4443 ">
Advertisement
Key features
- Froths milk
- Heats milk
- Automatic shut-off
- Adjustable frothing levels
- Easy to clean
- Compact design
- Multiple colors
- Safety features
Frequently asked questions
Fill the jug with milk up to the MAX FROTH marking. Put the whisk for frothing into the whisk holder. Switch on the power button. The power button lights red. The appliance starts to make milk foam and stops automatically as soon as the foam is finished.
Put the whisk for frothing into the whisk holder. Press the power button twice, it blinks red. The whisk rotates with reduced speed to ensure even heat distribution and prevent the milk from burning.
Put the whisk for frothing into the whisk holder. Switch on the appliance. Press the power button for approximately 2 seconds until it lights blue. Now cold milk froth is made.