DATA SHORT
To request the full datasheet, please visit www.intersil.com/products/TW8827
TW8827
Analog LCD Panel Processor with built-in MCU NTSC/PAL./SECAM Decoder and
TCON
FN7766
Rev.0.00
February 10, 2011
Analog Video Decoder
NTSC / P AL / SECAM
TUNER
DIGITAL
TECHWELL
TW8827
RGB/YPBPR
AUDIO
AMP
NTSC (M, 4.34) and PAL (B, D, G, H, I, M, N, N combination),
PAL (60), SECAM with automatic format detection
• Advanced synchronization processing for VCR trick play
signal
• Two 10-bit ADCs and analog clamping circuit.
• Built-in analog anti-aliasing filter
• Fully programmable static gain or automatic gain control
for the Y or CVBS channel
ANALOG TFT PANEL
Applications
• Mobil LCD TVs
• Rear seat entertainment
• Portable DVD, PMP and HMD (Head Mount Display)
Features
The TW8827 is a low cost high quality TFT panel controller with
embedded NTSC/PAL/SECAM TV decoder. It incorporates all
the features required to create multi-purpose low cost LCD TV
systems in a single package. It contains all the circuits
required to adapt standard NTSC/PAL/SECAM analog TV input
signals as well as digital RGB signals for display on various TFT
LCD panel types. An integrated timing controller and triple
DACs allows direct interface with analog LCD panels. Its
versatile analog inputs allow CVBS, S-video and RGB signal to
be connected simultaneously.
Other features include: high quality adaptive 4H Comb Filter,
interlaced and progressive ITU601, interlaced ITU656 and
RGB656 inputs support, 2D de-interlacer and panaromic
scaler, and multi-window programmalbe OSD. It also
includes image enhancement functions such as black and
white stretch, 2D peaking, CTI, and favorite color
enhancement to further improve picture quality. To support
analog panel, it also includes cost saving feature like CCFL
and LED controller, charge pump booster and
programmable panel offset control. In addition, TW8827 has
built-in microcontroller with external SPI interface.
• Programmable white peak control for the Y or CVBS channel
• Software selectable analog inputs allows any of the
following combinations:
• 3 composite video
• 1 S-Video
• 4-H adaptive comb filter Y/C separation
• PAL delay line for color phase error correction
• Digital PLL for both color and horizontal locking
• Programmable hue, brightness, saturation, contrast,
sharpness, Gamma control, and noise suppression
• Automatic color control and color killer
• Detection of level of copy protection according to
Macrovision standard
Digital interface
• Support both interlaced and progressive ITU 656 source.
• Support 16bit RGB source
Built-in Microcontroller
• Support external SPI Interface
• Support I2C Master interface with GPIO
• Support Up to 8 MCU GPIO
• Support UART interface with GPIO
• Support IR or interrupt with GPIO
TFT Panel Support
• Supports a wide variety of Analog active matrix TFT panels
up to WQVGA (480 x 234), 20 MHz
On Screen Display
• Built-in OSD controller with integrated character ROM and
programmable RAM font.
• Multi-window OSD support with color pallet
• Support OSD overlay with alpha blending
FN7766 Rev.0.00
February 10, 2011
Page 1 of 2
TW8827
Image Control
• Programmable hue, brightness, saturation, contrast
• Sharpness control with vertical peaking
• Programmable color transient improvement control
• Built-in de-interlacing engine
• Independent RGB gain and offset controls
• Panorama / Water-glass scaling
• YCbCr hue adjustment
• Programmable Gamma correction tables
• Built-in YCbCr to RGB color space converter
• Black/White Stretch
• Programmable favorite color enhancement
Power Management
• Supports Panel power sequencing.
• Supports DPMS for monitor power management.
• 1.8 / 3.3 V operation
Timing Controller (TCON)
• Support programmable interface signals for control
Column (source) driver / row (gate) driver
Miscellaneous
• Supports 2-wire serial bus interface
• Spread spectrum PLL
• CCFL controller
• LED controller
• Low-speed ADC for KEY scan
• 5V tolerant I/O
• Power-down mode
• Typical power consumption
• less than 250mW
• Single 27MHz crystal
• 80-pinTQFP package
© Copyright Intersil Americas LLC 2011. All Rights Reserved.
All trademarks and registered trademarks are the property of their respective owners.
For additional products, see www.intersil.com/en/products.html
Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted
in the quality certifications found at www.intersil.com/en/support/qualandreliability.html
Intersil products are sold by description only. Intersil may modify the circuit design and/or specifications of products at any time without notice, provided that such
modification does not, in Intersil's sole judgment, affect the form, fit or function of the product. Accordingly, the reader is cautioned to verify that datasheets are
current before placing orders. Information furnished by Intersil is believed to be accurate and reliable. However, no responsibility is assumed by Intersil or its
subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or
otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
FN7766 Rev.0.00
February 10, 2011
Page 2 of 2