Pannan V65
Boiler for
wood burning
Suction fan
Boiler for wood burning
55-80 kW
90 % efficiency
0.5 m log length
The suction fan is easily accessable
from the backside for sweeping and
service.
High-efficient cinder bed
heating-bed
150 l fire place
To be used with an
accumulating tank of
2000-4000 litres
V65 has a fire place of 150 litres
allowing 0.5 m log length. Thus
it creates effective and longlasting
heat with few replenishments.
Complete kit combinations
for wood
heating
V65 is designed
for connection to
an accumulator
tank with a
recommended volume of
2000-4000 litres. Contact your dealer
for more information.
Mounting opening for
pellet burner
V65 is also available in a version
with opening on right or left side
for fitting a pellet burner. Most
pellet burners on the market can
be installed.
Tested and approved
in accordance
with EN303-5
Sveriges Provnings- och Forskningsinstitut
Pannan V65
Efficient wood heating
3
Three-stage combustion for optimal heating result and
minimal environmental effect
Calmar Pannan V65 is a Swedish-made boiler,
designed in accordance with European environmental
requirements. All heating surfaces are made of 5 mm
structural steel.
1
2
3
1
2
The logs are evaporized on the ceramic rost in the fire
place, from where the exhaust gas is led down to the
convection section.
By means of the secondary air the exhaust gas will
reach a nearly complete combustion in the convection section, where the exhaust gas temperature is
900-1000 °C.
The exhaust gas will then pass through six watercooled tubes in the rear smoke chamber. The exhaust
temperature is 220-230 °C when leaving the boiler.
Technical Data
Dimensions
WALL
Front
Dimensions (mm)
Side
Top
680680 680
355355 355
V65 is available in
a version with side
opening for pellet
burner (option)
Chimney recommendations
The boiler has to be trimmed to achieve
optimized efficiency. The exhaust gas
temperature must match the chimney in
order to avoid condensation problems.
Contact your local chimney-sweep for
advice. A draught limiting device can be
installed if needed. The max. load for the V65
boiler is 500 kg, which has to be considered
when the chimney is top-mounted.
The boiler should be connected to an
accumulator tank with a min. volume
of 2000 litres. The recommended max.
volume is 4000 litres.
Height A incl. pipe c/c
Height D boiler
Width B
Depth C
Length E smoke pipe c/c
Height F smoke pipe
Width G smoke pipe
Expansion connection DN
Hot water return DN
Cooling coil
1588
1538
602
1026
500
100
168
40
40
12
Technical data
Output, kW
55-80
Water volume, litres
150
Fireplace height, mm
700
Fireplace width, mm
390
Fireplace depth, mm
550
Fireplace volume, litres
150
Log length, m
0.5
Chimney recommendation,
mm water column
1.5 - 2.5
Weight, kg
360
Art.no.
611 5371
Dealer
www.trebema.se