MD6923 Owner`s Manual MD6923 Owner`s Manual

CD BOOMBOX
with AM/FM Radio
OWNER'S MANUAL
PLEASE READ BEFORE OPERATING THIS EQUIPMENT.
MODEL: MD6923
Size: 148.5(W) x 210(H)mm (A5)
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS PRODUCT TO
RAIN OR MOISTURE.
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, AND ANNOYING INTERFERENCE, USE
THE RECOMMENDED ACCESSORIES ONLY.
For example,
this unit may not have the capability to be connected to an outdoor antenna.
60Hz
six
AC 120V~;
"C" size batteries (not included)
AC 120V~; 60Hz
six (6) "C"
7. Clean the batttery contacts and also those of the device prior to battery installation.
LOCATION OF CONTROLS
1
2
REPEAT/
PROG.
3
PROG.
4 5 6 7
9
8
10
PROG.
12
11
13
15
14
16
17
TUNING
VOLUME
FM
AM
CD/AUX
AUX
AC~I N
18
19
RADI O
1. Handle
2. CD door
3. REPEAT/RAND (Repeat/Random) button
4.
Stop button
5.
button
6.
button
7.
button
8. PROG. (Program) button
9. LCD display
10. POWER (Power on) indicator
11. Left speaker
12. Right speaker
13. TUNING knob
14. FM-AM band switch
15. AUX (in) jack
16. Function selector
17. VOLUME knob
18. AC~IN socket
19. Battery compartment (bottom side)
OPERATION
Radio:
1. Slide the Function selector to RADIO position to turn on the radio.
2. Slide the AM-FM band switch to AM or FM as desire.
3. Turn the TUNING knob to receiving the desired radio station.
4. Turn the VOLUME knob to adjust volume level as desire.
5. When finished listening, slide the Function selector to OFF position to power off the unit.
Antennas:
This unit has a build in AM and FM antennas, which provides adequate reception in most areas. If
reception is weak, turn or relocate the unit to improve reception.
CD:
1.
2.
3.
4.
5.
A.
B.
C.
D.
6.
7.
Slide the Function selector to CD/AUX position to turn on the CD.
Open the CD door then place a CD disc on the center spindle, with the printed side face up.
Close the CD door and wait a few seconds. The number of the total tracks will appear on the display.
Press the (Play/Pause) button to start playback the first track on the disc. Indicator "PLAY" will
appear on the display.
During playback:
Turn the VOLUME knob to adjust volume level as desire.
Press the (Play/Pause) button to pause (Indicator "PLAY" on the display will blink); press again to
resume normal playback ( Indicator "PLAY" on the display will stop blinking).
Press the or buttons repeatedly to skip the tracks.
Press and hold the or buttons to fast searching the specific section then release it to
resume normal playback.
To stop CD playback, press the ■ (Stop) button. The total number of tracks will appear on the display.
When finished listening, slide the Function selector to OFF position to power off the unit.
Repeat/Random Playback:
1. During playback, press the REPEAT/RAND (Repeat/Random) button once. The repeat one indicator
will appear on the display. The current track will playback repeatedly.
2. During playback, press the REPEAT/RAND button twice. The repeat all indicator
will appear
on the display. All the tracks on the current disc (or program) will be playback repeatedly.
3. During playback, press the REPEAT/RAND button three times, the indicator "RAND" (Random) will
appear on the display. The unit will plays the tracks randomly.
4. To cancel the repeat and random play functions, press the ■ (Stop) to stop playback.
Programmed Playback:
Up to 20 tracks can be programmed playback as follows:
1. In CD STOP mode, press the PROG. (Program) button. “"P 1 --"” will appear on the display and
blinking.
2. Select the first specific track to be programmed by pressing the or
buttons repeatedly..
3. Press the PROG. (Program) button to store the selected track into the memory.
4. Repeat steps 2 and 3 until all the specific tracks stored into the memory.
5. Press the
Play/Pause button to start playback. The program indicator "P PLAY" will appear on the
display.
6. To stop playback, press the ■ (Stop) button.
7. To cancel the program, press the ■ (Stop) button again in stop mode. The program indicator will
disappear on the display.
Note: Random play is not available in Program playback mode.
AUX (in):
1.
2.
3.
4.
Slide the Function selector to CD/AUX position to power on the unit.
Connect the external audio device with a 3.5mm AUX cable (AUX cable not included).
Insert one end to the Phone; Line Out or AUX Out jack on the external audio device.
Insert the other end to the AUX (in) jack on the rear of unit Indicator "AUX" will appear on the
display.
Note: In this mode, the CD Player will not function. Unplug the cable from the unit
before using CD Player.
5. Play the music on the connected external audio device as usual.
6. Turn the VOLUME knob to adjust volume level as desired.
7. When no longer in use, slide the Function selector to OFF position to power off the unit.
NOTES:
Make sure the sound output level of the connected external audio device in high level.
Otherwise, sound will weak.
●
If sound is distorting, reduce the volume of the connected external audio device or set the
EQ mode of it to normal.
●
Install the batteries as the batteries
polarity marks inside the battery
compartment.
Replace the old batteries by new
batteries.
Set Function selector to CD/AUX
or RADIO
VOLUME
Turn the VOLUME knob clockwise
to increase sound level.
Relocation or turn the unit to a new
location or direction for better radio
reception.
Try others disc.
Disc not good or badly scratched.
CD/AUX
CD/AUX
the printed side face up.
Close CD door completely.
Power Source
120V~; 60Hz, 10W DC
9V (6 x "C" size batteries, not included)
800 mW×2
30
kHz
MHz
; 3W x 2
ACCESSORIES:
1 x AC Power Cord
1 x User's Manual
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE
LIMITED WARRANTY
Craig Electronics warrants this product to be free from manufacturing defects in
material and workmanship under normal use for a period of 180 days from date of
purchase. If service is required, please return the product to the store where it was
purchased for exchange; or, pack the unit in the original packing material with all
accessories if applicable, a copy of your sales receipt and a Cashier’s check or Money
Order for $7 (to cover shipping and handling costs) payable to Craig Electronics Inc.
For consumers in Canada, please make sure that the cashier check or money order is
redeemable through a U.S. bank. Ship your product freight pre-paid. Your unit will be
repaired, replaced or if the unit can not be repaired or replaced, a refund will be
forwarded to you within four weeks of receipt of your unit. Please ship your unit to:
Craig Electronics Inc.
1160 NW 163 Drive
Miami, Fl 33169
This warranty is void if the product has been: a) Used in a commercial application or
rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by
anyone other than an authorized Craig service center. d) Damaged because it is
improperly connected to any other equipment.
Note: This warranty does not cover: a) Ordinary adjustments as outlined in the Owner’s
Manual which can be performed by the customer. b) Damage to equipment not properly
connected to the product. c) Any cost incurred in shipping the product for repair. d)
Damage to the product not used in the USA.
This warranty is not transferable and only applies to the original purchase. Any implied
warranties, including the warranty of merchantability, are limited in duration to the period
of this expressed warranty and no warranty whether expressed or implied shall apply to
the product thereafter.
Under no circumstance shall Craig be liable for any loss or consequential damage arising
out of the use of this product. This warranty gives specific legal rights. However, you may
have other rights which may vary from state to state. Some states do not allow limitations
on implied warranties or exclusion of consequential damage. Therefore, these
restrictions may not apply to you.
This product has been manufactured by and is sold under the responsibility of Craig
Electronics Inc, and Craig Electronics Inc is the warrantor in relation to this product.
MAGNAVOX and SMART. VERY SMART are registered trademarks of Koninklijke Philips
N.V. and are used under license from Koninklijke Philips N.V.
To Obtain Service on your Product
email:service@craigelectronics.com
Printed in China
MD6923_WC_E0HQ1_B0WU