SUPPLEMENT INSTRUCTIONS
Copy Part# 766521, Rev. E, 08/2013
Page 1 of 2
BACK MOUNT KIT
PART # HA5418
This kit is designed to retrofit a new SeaStar helm
into a larger dash cut out (4.5") or reduce helm
protrusion from the dash by the thickness of the dash.
HELM
MOUNTING
STUD
5" SQUARE
ALUMINUM
PLATE
CARRIGE BOLT
5" SQUARE
PLASTIC BEZEL
DASH
HELM PUMP
FLAT
WASHER
1/4" NC
SELF-LOCKING
NUT
Figure A.
1. Place the Aluminum Plate over the Helm Mounting Studs.
2. Insert the Helm through the rear of the dash and insert the
4 Carriage Bolts through the Plastic Bezel, dash and
Aluminum Plate.
3. Apply the Flat Washers and Nuts to the Carriage Bolts and
tighten to 110in-lbs Max.
4. Fill and Purge as per your Helm instructions.
5. If your dash is new, please use the attached mounting
template on page 2.
© 1999 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6
Fax: 604.270.7172
Web: www.seastarsolutions.com
SUPPLEMENT INSTRUCTIONS
Copy Part# 766521, Rev. E, 08/2013
Page 2 of 2
BACK MOUNT KIT #HA5418
This kit is designed to retrofit a new SeaStar helm
into a larger dash cut out (4.5") or reduce helm
protrusion from the dash by the thickness of the dash.
WARNING
Refer to page 1 for important insallation information.
CAUTION
If printing or photocopying of this template is required, please
check all measurements BEFORE you drill any holes to ensure
that the template you have printed is true and correct.
4" (102 mm)
Figure B.
4-1/2" DIA.
(115 mm)
4"
(102 mm)
4 HOLES, 5/16" (8 mm)
© 1999 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6
HELM FLANGE OUTLINE
5" (127 mm) SQUARE
c/w 1/2" (13 mm) CORNERS
Fax: 604.270.7172
Web: www.seastarsolutions.com