CDIBMAG | Car CD Slot Magnetic Mount Holder rev.092517 Package Contents: GNCDSLOT – Car CD Slot Pedestal with 17mm Ball Head SPIBMAG – Magnet Mount Kit NOTE: Make sure CD slot is empty before using. GNCDSLOT SPIBMAG 1 Remove paper backing from adhesive metal plate. Firmly press the adhesive side to clean, back surface of your smartphone or case. 2 Attach magnet mount head to CD slot pedestal by placing adjustment ring over the pedestal ball and snapping mount head onto pedestal. Tighten ring to secure. Adjustment Ring Metal Plate (Smartphone not included, sold separately) IMPORTANT: Do not overtighten ring. Overtightening ring may damage threads on holder and also make it difficult to adjust holder. 3 Slide mount into car CD slot. Use lever (A) to secure the mount to the CD slot (B). 4 Place metal plate on the smartphone in contact with the magnet head on the mount to attach. Rotate or adjust angle as needed. A B ! Safety Precautions Do not install Arkon products over an air bag cover or within the air bag deployment zone. Arkon Resources, Inc. assumes no responsibility of liability for injury or death as a result of car crashes and / or air bag deployment. Arkon is not responsible for any damages caused to your vehicle, your device, or yourself due to the installation or use of this mount. The Mobile Mounting Specialists™ Consumer Hotline: USA (800) 841-0884 INT’L (626) 254-9005 Monday - Friday 9am - 5pm, PST www.arkon.com Arcadia, CA 91006 USA Designed in USA | Made in USA & China © Copyright 2017 Arkon Resources, Inc.