Burglar Keypad Quick Reference Guide Arm -Check to see all zones are closed. -Check for green ready light. -Enter your 4 digit security code. -Red armed light should illuminate. Disarm -Enter using the entry / exit or delay door. -The keypad will sound an audible remind tone. -Enter your 4 digit security code. -Green ready light should illuminate. Stay (Residential Use Only) -Press the stay button for approx. 2 seconds -It should give you an audible beep. Armed & bypass lights should illuminate. - Bypass indicates motion devices are bypassed. -Perimeter devices have been armed. Away (Residential Use Only) -Press the away button for approx. 2 seconds -The keypad will provide an audible beep when activated. -ALL zones have been armed. -Red armed light should illuminate. Chime -Activate door chime feature by pressing the chime button for approx. 2 seconds or until keypad beeps 3 times. -Doors will chime when opened and closed. -Deactivate door chime feature by pressing the chime button for approx. 2 seconds or until keypad beeps 1 steady tone. Fire (Flame Symbol) - Use for Dispatch of fire department -Press both Fire keys simultaneously for 2 seconds to send an audible fire alarm. Panic (! Symbol) -Use for Dispatch of police -Press both Panic buttons simultaneously for 2 seconds to send a silent panic alarm. Police (Badge Symbol) -Use for Dispatch of police department. -Press both buttons simultaneously for 2 seconds to send an audible panic alarm. Trouble Light -When the yellow light is illuminated use the following steps for trouble shooting. 1. Press * 2 2. Note which zone light comes on 3. Press # key to silence keypad if beeping. 4. Call service department for assistance 305-235-2390 Memory Light -System has been violated while armed. -Call service department for assistance 305 235-2390 -If service is not required the memory light will go out after normal arming and disarming of the system. Reset Key -Reset is used only in the event your fire system has tripped and needs to be reset. -The trouble light will be illuminated, please call service to verify trouble status before using the reset key. Exit -Pressing the Exit button until keypad beeps will allow you to exit thru an Entry / Exit door without disarming. - After you have exited the system will return to the previously # Key -If you are having difficulty arming the system press the # key armed state. and re-enter your alarm code. - The # key acts as a clear entry function for your system.