Timer [START/STOP] Setting
MAGNET
1. After time setting is ready, press the [START/STOP] button
once and the timer will start to count down. The “M” and “S”
marks will flash when the timer is counting.
2. Press the [START/STOP] button once and the timer will stop.
The “M” and “S” marks will stop flashing.
3. Press the [START/STOP] button once and the timer will
resume counting.
4. After the buzzer stops, press the [START/STOP]
button once and it will return to the last time setting.
CLIP
Timer Buzzer Alarm
LCD Digital Timer
8014291A
Instruction Manual
Main Feature
BATTERY COVER
1. LCD countdown timer
2. 4-digit display showing minutes (“M”) and seconds (“S” mark).
3. Timing Range: 1~ 99 minutes, 59 seconds.
4. Buzzer sound when timer counts down to the last second.
5. Timer memory recall function.
6. [MIN], [SEC] individual buttons for minute and second settings.
7. Clockwise function.
Timer [Min] and [SEC] Settings
1. Press the [MIN] button to advance the minute digits (deep
sound can be heard).
Press and hold [MIN] button for speed setting.
2. Press the [SEC] button to advance the second digits (deep sound can be heard).
Press and hold [SEC] button for speed setting.
3. Press and hold the [MIN] and [SEC] buttons at the same time
to reset the timer to zero.
1. When the timer counts down to 00M 00S the timer buzzer will
sound for 30 seconds.
2. Buzzer can be stopped by pressing any button.
Timer Memory Recall
1. After the buzzing stops, press the [START/STOP] button once
to recall the preset time and the timer will count down for
another lap.
2. Press the [START/STOP] button once and the timer will count
down for another lap.
Clockwise Function
• Press the [MIN] and [SEC] buttons at the same time. When
the display shows 00M 00S press the [START/STOP] button
once to start the clockwise function.
Battery Replacement
1. Follow the arrow direction to open the battery cover on the
back of the timer.
2. Remove the old battery and insert a new AAA battery following
the polarity markings as indicated by the symbols (+ and -) on
the battery cover.
Clip Attachments
1. The timer can be clipped to a thin board or a shirt pocket
using the plastic clip on the rear of the timer.
2. The timer also has a magnet on the back to attach it to any
magnetic surface.
3. The timer can also stand on a table surface by flipping out the
metal stand bar located on the back of the unit.
THE SOURCE – WARRANTY
The Source warrants that this product will be free from defects in materials and
workmanship for a period of one (1) year from the date of purchase. Within this
period, simply take the product and your proof of purchase to any The Source
store or participating dealer and the product will be replaced (where available)
without charge. Any product which has been subject to misuse or accidental damage is excluded from this warranty.
This warranty is only applicable to a product purchased through The Source
company-owned stores or participating dealers in Canada where the warranty is
included with the product. While this warranty does not confer any legal rights
other than those set out above, you may have additional statutory rights which
will vary under the laws of the various countries, states, provinces and other
governmental entities in which The Source operates. This warranty is subject to
all statutory rights you may have in Canada.
Imported by:
The Source,
Barrie, Ontario, Canada, L4M 4W5
Please
Recycle
Manufactured in China
For product support please visit
www.thesource.ca
© 2015 The Source
All rights reserved.