FITTING INSTRUCTIONS FOR BLP0017BK FOOTREST BLANKING PLATE
TRIUMPH DAYTONA 675 2005-
Please note that the way the kit is packed does not necessarily represent the way of
mounting to the bike
THE PARTS SHOWN MAY BE REPRESENTATIVE ONLY (FOR CLARITY OF INSTRUCTIONS ONLY)
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt –
the rubber washers should be thrown away!
TOOLS REQUIRED

6mm metric Allen key.
FITTING INSTRUCTIONS




Remove the rear footrest from the rear subframe by un-doing the original nut & bolt.
Locate the footrest blanking plate in place. The two bosses will locate into the subframe holes.
Fit two button head bolts with one washer on each bolt through the holes in the subframe from the
back side and into the thread of the blanking plate.
Tighten evenly using 6mm Allen key.
ISSUE 1 22/06/2012 (AR)
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301 www.rg-racing.com Email: info@rg-racing.com
-1-
Instructions de montage
BLP0017BK Plaque de repose-pieds
TRIUMPH DAYTONA 675 2005-
La façon dont le kit est emballé ne représente pas nécessairement la façon de le monter sur la moto.
Les parties représentées peuvent parfois être uniquement représentatives
(Pour la clarté des explications).
Notez que dans les cas où les kits sont emballés avec des rondelles en caoutchouc, composantes du
boulon - les rondelles en caoutchouc doivent être jetées !
Outils requis

Clef Allen 6mm
Instructions de montage




Enlever le repose-pied arrière du sous cadre arrière en desserrant l’écrou d’origine et le boulon.
Mettre la Plaque de repose-pieds en place. Les 2 patrons se placeront dans les trou dans le souscadre.
Mettre 2 boulons à tête ronde avec uen rondelle sur chaque boulon à travers les trous dans le souscadre du coté inférieur et dans le filetage de la plaque repose pied.
Serrer de façon égale avec une clef Allen de 6mm.
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301 www.rg-racing.com Email: info@rg-racing.com
-2-
ISSUE 1 22/06/2012 (AR)
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G’s order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for
its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify
any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
than in accordance with R&G’s or manufacturer’s instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be
liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or
the fitting or service concerned. These terms do not affect the Buyer’s statutory rights.
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in resellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value
exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of
discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty
goods.
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301 www.rg-racing.com Email: info@rg-racing.com
-3-
Download PDF

advertising