SPEAKMAN COMPANY
S-2252 Installation, Maintenance & Operation Instructions
ANYSTREAM ® SHOWERHEAD
DESCRIPTION
Polished chrome plated ANYSTREAM showerhead. Brass ball swivel joint. Brass shank. Contoured polished
chrome plated brass spray adjusting handle. Polished chrome plated 2-3/4” face. 6 Lexan deposit resisting
plungers with 48 spray channels. Water conserving pressure compensating AUTOFLO® device reduces flow to 2.5
GPM/9.46LPM maximum, to meet existing ANSI A112.18.1 Standard. ½” NPT inlet.
SPECIFICATIONS
SUPPLY INLET: ½” NPTF
FLOW RATE: 2.5 GPM/9.46LPM
MAX.
SHIPPING WEIGHT: 1.26 LBS.
OPTIONS
◊ ORB: Oil Rubbed Bronze
◊ PB: Polished Brass PVD Coating
◊ BPT: British Pipe Thread
◊ BN: Brushed Nickel
◊ PN: Polish Nickel
◊ S-2252-E2: Low Flow Showerhead
(2.0 GPM/ 7.6 LPM)
INSTALLATION
Apply pipe thread tape in a clockwise direction to threads of shower arm. Pipe joint compound may be used instead
of tape. Turning in a clockwise direction, thread the shower head on to the shower arm. Tighten with a pipe wrench
or a pair of pliers. Position the shower head by rotating it clockwise. Make sure the ball joint coupling nut is properly
tightened. Turn the water supply on and check for leaks. NOTE: THE S-2252 SHOWERHEAD FACEPLATE HAS
A CLEAR PROTECTIVE COVER WHICH CAN BE REMOVED BY RUNNING THE FACEPLATE UNDER WARM
WATER AND THEN REMOVING THE COVER WITH ANY ONE-SIDED TAPE.
OPERATION
To adjust the spray pattern of the shower head, simply rotate the handle to the
desired spray (needle spray, gentle rain or full flood).
Product improvements may cause
specification and dimensional
changes without notice.
MAINTENANCE
Your Speakman showerhead is designed and engineered in
accordance with the highest quality and performance
standards. Periodic cleaning using a mild soap and warm
water will help keep your showerhead’s appearance in its
original condition. For best results, dry immediately with a soft,
clean cloth. Do Not Use harsh and/or abrasive cleaners on
showerheads. To help restore your finish, occasionally apply a
non-abrasive wax to your showerhead body (Follow
manufacturer’s instructions). In certain water conditions,
mineral deposits may form on your faceplate. To reduce the
mineral build-up, turn the handle to FLOOD position to let the
water drain out after every use. A gentle scrubbing of the
plunger or channels with a toothbrush should restore your
spray pattern. On chrome plated showerheads, a white
vinegar/water treatment will assist in breaking down excessive
mineral deposits on the sprays. The showerhead faceplate
can be soaked in a two (2) parts white vinegar and (1) part
water solution for about ½ hour to break up the mineral
deposits. Rinse thoroughly. Brush off any remaining mineral
deposits if necessary. CAUTION: On all special finish parts,
including any of the nickel or brass finishes, the white
vinegar/water treatment should not be used.
SPEAKMAN
ROUGH-IN MEASUREMENTS
®
PO Box 191 Wilmington, DE 19899
Phone: 800-537-2107 Fax: 800-977-2747
Visit us on the web at www.speakmancompany.com
03/11
REV 2
92-3206