VH1 S1500_5S - ICON Technology Systems

Product
Specification
VH1 S1500_5S
Valved Head
Cleaner thinking. Greener solutions.
31/6"
80mm
Applications
• H
ot Beverage Applications (including Office Coffee Services)
• Removal of Chlorine, Taste, Odour (CTO) and Particulate
• Scale inhibition
• R
e-usable cartridge based system results in significant
reduction in carbon footprint and cost
• Hygienic, sealed filter cartridge prevents contamination at
all times
• Valved head allows rapid, dry change of replacement cartridge
• Produces cleaner, safer, better tasting water
• Scale inhibition helps protect equipment from the harmful
effects of hard water - reduces maintenance and down time
• Independently tested and certified for design and
performance by NSF International and WRAS
288mm (max)
111/3"
Product Benefits
Product Specifications
Accreditations
• NSF 42 - CTO & Particulate
• WRAS approved
Visit www.NSF.org or
www.eco3filtration.com for
the claims associated with
products that are NSF listed
Cartridge Part Number
VH1-C S1500_5S
Capacity
1500 US gal / 5,678 L
Flow Rate (per minute)
0.55 US gal / 2.1 L
Degree of Filtration
5 micron nominal
Min Water Temperature
39oF / 4oC
Max Water Temperature
100oF / 38oC
Min Water Pressure
10 psi / 0.7 bar
Max Water Pressure
120 psi / 8.5 bar
Inlet / Outlet
1
Height (incl head)
11 1/3" / 288mm
Diameter
3 1/6" / 80mm
Fittings
1
/4" BSPT
/4" push fit or integral
Cleaner thinking. Greener solutions.
Installation/Replacement Tips
•
•
•
•
•
On installation allow room around the clamp
ring to grip and rotate
Minimum 30mm vertical clearance below base
of housing for cartridge change
On replacing cartridge in sump, align arrow on
cartridge top metal plate with arrow on sump
– insert and rotate clockwise as per “IN” arrow
to stop
To reconnect to head, align arrows on head and
sump, push sump into head and rotate clamp
ring counter-clockwise
Apply new change date label over existing main
product label
Operation Tips
•
•
•
Change cartridge every 6 months
Change cartridges when capacity is reached or
when pressure falls below 10 psi
Flush for 2 litres following initial installation
and cartridge change
Warranty
eco3 systems (excluding replacement cartridges) are covered by a limited warranty against defects in material and
workmanship for a period of 5 years after date of purchase. Replacement cartridges are covered by a limited warranty against
defects in materials and workmanship for a period of 1 year after date of purchase.
Warning
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after
the system. Install in cold water applications only. The contaminants removed by this water filter are not necessarily present
in all water. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts.
For cooler applications only, not intended for use in general plumbed-in applications.
We recommend regular replacement of the filter cartridges - change the cartridge at least every 6 months.
Do not install if water pressure exceeds 120 psi. If your water pressure exceeds 80 psi, you must install a pressure limiting
valve. Do not install where water hammer conditions may occur. If water hammer conditions exist you must install a water
hammer arrester. Contact a plumbing professional if you are uncertain how to check for these conditions. Installation and use
must comply with all State and local plumbing laws and regulations. Improper installation may result in property damage due
to water leakage.
For replacement parts or further product information contact
& Europe:+44 161 941 6003
www.eco3filtration.com | UK
USA: +1 877 291 0330
Icon Technology Systems Limited, The Court House, Altrincham, UK, WA14 1DU
PO Box 801208, 5330 Brookstone Dr, NW STE 250, Acworth, GA 30101
Download PDF

advertising