Raspberry Pi 7” Touch Screen Display

Raspberry Pi 7” Touch Screen
Fact Sheet
The 7” Touch screen Monitor for Raspberry Pi gives users
the ability to create all-in-one, integrated projects such as
tablets, infotainment systems and embedded projects.
The 800 x 480 display connects via an adapter board
which handles power and signal conversion. Only two
connections to the Pi are required; power from the Pi’s
GPIO port and a ribbon cable that connects to the DSI port
present on all Raspberry Pi’s. Touch screen drivers with
support for 10-finger touch and an on-screen keyboard
will be integrated into the latest Raspbian OS for full
functionality without a physical keyboard or mouse.
Technical Specification
7” Touch screen Display.
Screen Dimensions: 194mm x 110mm x 20mm (including standoffs)
Viewable screen size: 155mm x 86mm
Screen Resolution 800 x 480 pixels
10 finger capacitive touch.
Connects to the Raspberry Pi board using a ribbon cable connected to the DSI port.
Adapter board is used to power the display and convert the parallel signals from the display to
the serial (DSI) port on the Raspberry Pi.
Will require the latest version of Raspbian OS to operate correctly.
Kit Contents
7” Touch screen Display
Adapter Board
DSI Ribbon cable
4 x stand-offs and screws (used to mount the adapter board and Raspberry Pi board to the back
of the display
4 x jumper wires (used to connect the power from the Adapter Board and the GPIO pins on the
Pi so the 2Amp power is shared across both units)