ISIMET Solenoid Warranty/Recommended Usage Statement

ISIMET Solenoid Warranty/Recommended Usage Statement
Warranty:
ISIMET will repair or replace solenoids for a period of six (6) months after date of sale. Warranty will be extended
to one year where ISIMET Controller that operates the solenoid incorporates an auto shut-down master control.
Where solenoids are provided for applications where ISIMET does not provide the operation or control means then
warranty is limited to ninety (90) days. All other ISIMET terms, conditions and notices apply.
General Service Solenoids: ISIMET cannot warrant against the effects of hard water, corrosive agents,
contaminants, or debris present in the piping system or against effects of exotic or harsh substances.
Damage caused by incorrect installation or improper usage is not warranted. Failure to follow recommended
installation, operation, and/or maintenance procedures listed herein may void product warranty. Recovery rights
shall be limited to the total sum of the amounts paid for the product by the purchaser.
Recommended Usage:
Piping system should be thoroughly flushed prior to operation. If systems are operated without proper flushing, the
solenoid diaphragm may become fouled and may not close properly when solenoid coil is disengaged. Fouled
diaphragms will also cause coil failure. ISIMET recommends that fluid delivery systems be provided with shock
arrestors and in-line strainers. ISIMET cannot warrant against the effects of hard water, corrosive agents,
contaminants, or debris present in the piping system or against effects of exotic or harsh substances. Failure to
follow recommended installation, operation, and/or maintenance procedures listed in this manual may void product
warranty. Where enclosures are not specified with integral in-line strainers, one should be field provided upstream
of the solenoid. Solenoids should be de-energized when utility is not in use. Coils for 3” solenoids MUST be in the
upright vertical position.
NOTE:
Only qualified craftsmen licensed within the governing jurisdiction to perform the work associated with this
installation should install and/or service this equipment.
All local codes must be followed when installing these products and making the wiring connections.
DISCLAIMER OF IMPLIED WARRANTY:
THERE ARE NO WARRANTIES THAT EXTEND BEYOND THE DESCRIPTION HEREIN. SELLER
DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTABILITY OF THE GOODS OR OF THE FITNESS
OF THE GOODS FOR ANY PURPOSE, AND BUYER AGREES THAT THE GOODS ARE SOLD “AS IS.”
ISIMET, LLC
DOC# 15002
103 CJ Wise Parkway
Naples, TX 75568
(903) 897-0737
March 2014