Installation Instructions

Installation Instructions
Kado Lux Close Coupled Back to Wall Overheight Back Inlet
Toilet Suite with Thin Soft Close Quick Release Seat White (4*)
Set-Up
1. Rough in positions of water inlet,
waste outlet and fixing bracket
holes. Ensure inlet connection
extends 40mm from finished
wall. Prepare waste outlet
according to required setout
(120mm min - 180mm max) and
drill floor fixing brackets into
position (60mm inside traced
mark of pan rim).
2. Insert top-fix plastic fixing nut
and bolt into pan (supplied).
S-Trap Installation
1. Lubricate the rubber fins of
the pan bend and position in
the waste pipe at the required
height. Fix the pan connector
back to the wall using the rod
and bracket.
2. Align and push pan back to wall,
connect pan spigot into waste
bend ensuring firm connection.
3. Fix cistern onto pan, bucket
flush and check for leaks.
Water Inlet & Levelling Pan
1. Connect rear water inlet valve
using 15mm mini cistern stop
supplied. Fill the cistern and
ensure correct water level. For
adjustment refer separate inlet
valve instructions,
2. Ensure that pan is level and that
cisterns align with wall. Make
minor adjustments if necessary.
3. Fix pan to floor using screws
and caps provided
4. Silicone pan to floor. Remove
excess sealant.
80
790
Water Inlet
120-180
180
210
60
WALL
WALL
WALL
180
FINISHED FLOOR LEVEL
120-180mm
FINISHED FLOOR LEVEL
15mm Mini Ball Valve
Flexible Hose
ANT
SEAL
PUSH BUTTON ASSEMBLY AND ADJUSTMENT
Full flush
Half flush
Back Inlet
Connection
40m
m
Lock out
2
Finished
Wall
NOTE: Ensure back inlet connection
extends 40mm from finished wall
Tighten lock nut
1 Loosen lock nut
Adjustment
Ensure button rods are aligned with full & 1/2 flush on outlet valve.
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference