Low Volume Liquid Dispenser - Maxmega Electronics Pte Ltd

Low Volume Liquid Dispenser
The Liquid Volume Dispenser is designed to deliver a measured volume of liquid
at the press of a button. In normal use, the operator selects a volume, presses a
button and the Dispenser delivers the required volume without further operator
intervention.
The volume is easy to select and is retained in non-volatile memory for repeat
operation. Volumes between 0.025 litres and 10 litres can be selected in
increments of 0.001 litres.
The Dispenser will accurately measure volumes over a flow rate range of
between 0.2 litres/minute and 2.5 litres/minute and will automatically
compensate for the effects of varying flow-rates and changes in liquid
temperature. A calibration menu allows fine adjustments to the compensation.
The Liquid Volume Dispenser has two John Guest Speedfit® push-fit connectors
for fluid in and out. These take a tube with outside diameter of 8mm. Wetted
surfaces are nylon, PTFE, Buna and acetal, making the Liquid Volume Dispenser
suitable for a wide range of fluids.
Operator controls consist of a three-button keypad and a liquid crystal display.
The display shows the selected volume and progress during dispensing. A
number of additional features are available through the keypad, including pause
and restart during dispensing, cancelling dispensing, and manual ‘top-up’ control.
All electrical equipment should be installed by a qualified electrician.
DEETER ELECTRONICS INC
466 Commerce Street, Tallmadge, OHIO, 44278
Tel: 330 630 3510 Fax: 330 630 3512
sales@deeterelectronicsinc.com www.deeterelectronicsinc.com
Distributed by:
Low Volume Liquid Dispenser
The Dispenser has a serial communication option
to enable automated control and monitoring by
computer (software supplied). Communication is
via USB ‘A to B’ cable (not supplied).
The Liquid Volume Dispenser is powered by a
low-voltage supply, making it safe to use in
damp environments or if liquid is spilt. A 12VDC
mains socket adapter is supplied with each
Dispenser.
Specification
10-15VDC @ 500mA
Dimensions
175mm x 125mm x
78mm
Power supply
12VDC mains socket
adapter supplied
Dispense Volume
0.025 L – 10 L in
0.001 L steps
Flow Rate Range
0.2 – 2.5 litres per minute
Minimum inlet
pressure
0.2 Bar
Maximum inlet
pressure
at 20 °C up to 10 Bar
±1% at constant
temperature and
flow rate
Fluid
Temperature
(1)
Range
0°C to + 65°C
Fluid Connections
8mm OD, push-fit
Suitable Tube
(2)
Materials
Polyethylene, nylon,
polyurethane, brass,
copper, mild steel
USB connection
USB to serial
connection (Cable
not Supplied)
Software/CD
Dispense Accuracy
(1)
(2)
(1)
at 65 °C up to 4 Bar
User Guide
Software and Datasheet
Water
For soft or thin-walled tubing, tube inserts should be used.
Ordering Information
Description
Liquid Volume Dispenser
Ordering Code
DE012-0184
Deeter Electronics Ltd. follows a policy of continual development of its products and reserves the right to
change specifications and / or features without notice
All electrical equipment should be installed by a qualified electrician.
DEETER ELECTRONICS INC
466 Commerce Street, Tallmadge, OHIO, 44278
Tel: 330 630 3510 Fax: 330 630 3512
sales@deeterelectronicsinc.com www.deeterelectronicsinc.com
Distributed by: