PHOENIX FLOW SKEEK HOB BATH OUTLET 200MM

page 1 of 3
PHOENIX
FLOW SKEEK HOB BATH
OUTLET 200MM
104
146
43
52
208
54
SPECIFICATIONS
Recommended Use
Domestic, Commercial and Hotel
Finish Available
Chrome
Suitable Hot Water
Storage Tank: Yes
Continuous Flow: Yes
Gravity Feed: Yes
Standards
AS/NZS 3718
CLEANING RECOMMENDATIONS
To see the complete Phoenix range go to
www.reece.com.au/bathrooms
This bathroom product should not be cleaned with abrasive materials eg.
steel wool/scourers. Do not use any corrosive or abrasive cleaning agents
containing acids or scouring agents. Bleaches can also discolour products
and therefore should not be used. Damage caused by any improper
treatment is not covered by the product warranty- refer to Warranty
Conditions on the last page.
Disclaimer: Products in this specification manual must by regulation be installed by licensed and
registered trade people. The manufacturer/distributor reserves the right to vary specifications or
delete models from their range without prior notification. Dimensions are nominal measurements only.
Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor
takes no responsibility for printing errors.
Tech Page Version 1
Brand logo area
- grey box to be
deleted. Apply on
Master Page
page 2 of 3
PHOENIX
FLOW SLEEK HOB BATH OUTLET 200MM
INSTALLATION INSTRUCTIONS
Phoenix Flow Sleek Hob Bath Outlet 200mm INSTALLATION INSTRUCTION
2
1
Adaptor
a) Remove Grub Srew from
Spout Assembly to release
Adaptor.
Apply teflon tape to Elbow
b) Screw Adaptor to Elbow
Thread with a hexagon key
and ensure bottom of Adaptor
sits flat on mounting surface.
WATER SUPPLY REQUIREMENTS
3
Note:
-If the pressure exceeds or is likely to exceed
550kpa, an approved pressure limiting device must
be installed.
- Flush out all pipe work prior to installation.
- If the water temperature exceeds 75°C, an
approved tempering valve must be fitted.
- Installation should comply with Australian
standard AS3500.1 or relevant local authority
requirements.
4
Fasten Grub Screw to secure Outlet.
TEST & CHECK FOR LEAKS
Failure to comply with the above may void all
warranties.
Maintenance and Care
-Chrome plated surfaces should be cleaned with
mild liquid detergent or soap and water.
-Do not use cream cleaners or citrus based cleaning
products, as they are abrasive.
-Use of unsuitable cleaning agents may damage the
surface. Any damage caused in this way will not be
covered by warranty.
Push Spout onto
Adaptor, until Spout
is flush against the
mounting surface.
IN0140 revA
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
Brand logo area
- grey box to be
deleted. Apply on
Master Page
QU
AL
7
YEAR
IT Y
TE
PHOENIX
FLOW SLEEK HOB BATH OUTLET 200MM
E
page 3 of 3
G UARA
N
REECE PRODUCT QUALITY GUARANTEE
You have purchased a quality product from Reece Pty Ltd
ABN 84 004 097 090 (“Reece”). This product is covered by a
7 year replacement product warranty and a 12 month warranty
over spare parts and labour.
This warranty does not include faults caused by:
7 YEAR WARRANTY – DOMESTIC USE
This warranty covers faults in the product construction, material
and assembly. Products which are within 7 years from the
date of purchase, found upon inspection by an authorised
Reece representative, to be defective in construction, material
or assembly, will be repaired or exchanged with an equivalent
product free of charge. Replaced items become Reece’s
property. This warranty also covers any spare parts included
under “Manufacturer’s Provisions” below.
• Installation or part installation by the purchaser or any person
other than a LICENSED PLUMBER
All replacement products will be available for collection without
charge to the customer at the nearest Reece branch to the
customer’s location, or elsewhere as agreed between the
customer and Reece.
Labour and Spare Parts
The labour for the replacement of products and spare parts
to which this warranty applies will be supplied by Reece or
relevant supplier using licensed plumbers engaged by Reece or
relevant supplier within 1 year from the date of purchase.
Spare parts other than those listed in the Manufacturer’s
Provisions above, which are within 1 year from the date of
purchase found upon inspection by an authorised Reece
representative to be defective in construction, material or
assembly, will be replaced free of charge.
Warranty Conditions
This warranty will apply only under all of the
following conditions:
• The item has been installed by a licensed plumber
• The item has been installed for and subjected to domestic
residential use only
• Failure is due to a fault in the manufacture of the product
• Proof of purchase (including the date of purchase)
is provided
• The installation of the product is in accordance with the
instructions provided
• Incorrect installation or installation not in accordance with
the instructions provided
• Normal wear and tear
• Inadequate or complete lack of maintenance
• Chemical, electrochemical or electrical influences
• Harsh detergents or abrasive cleaners used on
product finishes
1 YEAR WARRANTY – COMMERCIAL USE
‘Commercial’ use is all use other than for normal domestic
residential purposes, including use in non-business places as in
public buildings, schools, sports centres and in establishments
that contain private bathrooms with high frequency of use by
many individuals, such as hotels, motels, retirement villages
and hospitals.
The Commercial warranty covers this product against
manufacturing faults in the construction, material and assembly
of both the finished products and any spare parts for a period
of 1 year from the date of purchase. Products and spare
parts which are found upon inspection by an authorised
Reece representative to be defective in construction, material
or assembly will be repaired or exchanged free of charge.
Replaced items become Reece’s property. The labour for the
replacement of products and spare parts to which this warranty
applies will be supplied by Reece or relevant supplier using
licensed plumbers engaged by Reece or relevant supplier.
The Warranty Conditions and exclusions which apply to the
domestic use warranty also apply to this commercial warranty.
EXCLUSIONS
To the fullest extent permitted by law, Reece excludes all liability
for damage or injury to any person, damage to any property,
and any indirect consequential or other loss or damage.
CLAIM PROCEDURE
For all warranty queries customers are to contact the branch
where the product was purchased. These details can be found
on your purchase invoice.
Our goods come with guarantees that cannot be excluded
under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
TAP.T1.7YR
This warranty does not cover products purchased as an
ex-display without being fully checked and tested for sale by
the manufacturer.
• Unsuitable or improper use
Don’t risk it, use a licensed plumber.™
Brand logo area
- grey box to be
deleted. Apply on
Master Page