self installation plumbing guide

SELF INSTALLATION
PLUMBING GUIDE
Turn on the ho
t
On average, your installation
should take between an hour
and an hour and a half.
under the sink. T h e o ne
When you have decided
where to locate you BIBO
identify a suitable mains
cold water supply nearby.
More often than not this
will be under your kitchen
sink or behind your
dishwasher or washing
machine.
WARNING PIPE CAN GET EXTREMELY HOT AND CAUSE BURNS.
and wait for the flowing water to get hot. Then feel both pipes
tap
As well as your BIBO the box contains a
self installation kit consisting of a 3m
length of 6mm water pipe, a BIBO 1/2
“T” connector with a ball valve, easy fit
elbow and UV filter key.
ho
3
the
touch is the hot water supply pipe.
Install the BIBO 1/2” “T”
connector into the main
water supply. Make sure
it is in the closed position.
b ack of the BIBO.
---
----
---ANGLE STOP VALVE
4
OPEN
B I B O. Push the pipe into the elbow a t t
CLOSED
he
“T” CONNECTOR
--------
Often there is an angle
stop valve. This enables
you to isolate the cold
water pipe. If not then it
will be neccessary to turn
off the main water supply
to your home. Be sure to
drain as much water as
possible from this pipe
before disconnecting it.
t
2
to
to
Connect the 6mm white pipe to the “T” connector and r u n it
FINAL
STEP:
OPEN THE BALL VALVE ON THE “T” CONNECTOR
AND THE ANGLE STOP VALVE
Download PDF