Operating instructions
Wine storage cabinet
Page 6
GB
7081 481-01
GWUes 1208
Disposal notes
• Keep packaging materials away from children - polythene
sheets and bags can cause suffocation!
• Please return the packaging to an official collection point.
Your old appliance: This contains some reusable materials
and should be disposed of properly - not simply with unsorted
household refuse.
• Discarded appliances should be disabled: Remove
the plug, cut through the connection cable and render
the catch unusable so that children cannot become
trapped inside.
• Ensure that the refrigerant circuit is not damaged when
the appliance that is no longer needed is taken away
for disposal.
• Details of the refrigerant can be found on the type plate.
• Appliances which are no longer needed must be disposed of
in a professional and appropriate way, in accordance with the
current local regulations and laws.
Range of appliance use
The appliance is suited only for cooling food. In the case of commercial food cooling, the pertinent statutory regulations have to
be observed.
The appliance is not suited for storing and cooling pharmaceuticals,
blood plasma, laboratory preparations or similar substances and
products subject to the Medical Devices Directive 2007/47/EC.
Any misuse of the appliance may result in damage to or spoilage
of the stored goods.
Furthermore, the appliance is unsuited for use in areas exposed
to an explosion hazard.
Climate rating
The appliance is set to operate within specific ambient temperature
limits according to its climate rating. These temperature limits
should not be exceeded. The correct climate rating for your appliance is indicated on the type plate.
Climate rating
Ambient temperatures
SN - ST
+10°C to +38°C
Description of appliance and equipment
Operating and
control elements
Interior light
Safety instructions and warnings
• To prevent injury or damage to the unit, the appliance should
be unpacked and set up by two people.
• In the event that the appliance is damaged on delivery, contact
the supplier immediately before connecting to the mains.
• To guarantee safe operation, ensure that the appliance is set up
and connected as described in these operating instructions.
• Disconnect the appliance from the mains if any fault occurs. Pull
out the plug, switch off or remove the fuse.
• When disconnecting the appliance, pull on the plug, not on the
cable.
• Any repairs and work on the appliance should only be carried
out by the customer service department, as unauthorised work
could prove highly dangerous for the user. The same applies to
changing the mains power cable.
• Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that
the refrigerant circuit is not damaged. In the event of damage,
make sure that there are no ignition sources nearby and keep
the room well ventilated.
• Do not stand on the plinth, drawers or doors or use them to
support anything else.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge unless they have been given
initial supervision or instruction concerning use of the appliance
by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
• Avoid prolonged skin contact with cold surfaces or chilled/frozen
food. This could cause pain, numbness and frostbite. In the case
of prolonged skin contact, protective measures should be taken,
e.g. gloves should be worn.
• Do not store explosives or sprays using combustible propellants
such as butane, propane, pentane etc. in the appliance. Electrical
components might cause leaking gas to ignite. You may identify
such sprays by the printed contents or a flame symbol.
• Do not use electrical appliances inside the appliance.
Setting up
• Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal
and level. To compensate for any unevenness, adjust the height
of the feet with the open-ended wrench supplied.
• Standard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m3 per 8 g of R 600a
refrigerant used in the appliance, so as to avoid the formation
of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit.
The quantity of refrigerant used in your appliance is indicated
on the type plate on the inside of the appliance.
Connecting to the mains
Power supply (a.c.) and voltage at the operating point must
comply with the details on the type plate, which is located in the
refrigerator compartment on the left-hand side. The socket must
be fused with a 10 A fuse or higher, it must be away from the rear
of the appliance and must be easily accessible.
Connect the appliance with a properly earthed fused plug
and socket only.
Pull-out shelf
Type plate
Adjustable-height feet
6
The wires in the mains lead are coloured in accordance with the following code: green/yellow = earth, blue = neutral, brown = live.
Warning! This appliance must be earthed.
GB
Installation dimensions (mm)
Changing over door hinges
Adjust to recess height using the 4 adjustable feet
on the underside of the appliance.
The ventilation cross-section in the plinth panel must be min.
300 cm².
Installation and fitting
• Connect the appliance to the mains.
• Slide the appliance into the recess.
• Secure the appliance in the recess using 4 x 14
screws.
Safety lock
The lock in the appliance door is equipped with a safety mechanism.
Locking the appliance:
• Insert the key as shown by arrow
1.
• Turn the key 90° anticlockwise.
To unlock the appliance, the same
procedure must be repeated
in the same order. Turn the key
clockwise.
7
Operating and control elements
➀ Temperature display
➁ Temperature setting buttons
➂ Audible warning on/off button
➃ Interior light on/off button
➄ Child-proof lock
➅ On/off button
➆ Fan switch
Switching the appliance on and off
Additional functions
You are recommended to clean the appliance before switching it
on for the first time (see "Cleaning").
In set-up mode you can set the child-proof lock and adjust the
brightness of the display. The child-proof lock is designed to protect
the appliance from being switched off accidentally.
To switch the appliance on: Press the ON / OFF button
until the temperature display lights up.
To switch the appliance off: Keep the ON / OFF button
pressed for 3 sec. so that the temperature display goes
out.
Setting the temperature
Activating set-up mode:
• Press Light button for approx. 5 secs. - The display shows c
for child-proof lock.
Note: The value to be altered flashes.
• Select the required function by pressing the UP / DOWN button:
c = child-proof lock, h = brightness of the display
To reduce the temperature: Press the DOWN
button;
• Now select/acknowledge the function by pressing the Light
button briefly:
To increase the temperature: Press the UP
button.
> For c = child-proof lock, press the UP / DOWNbutton to select
c1 = child-proof lock on or
c0 = child-proof lock off and acknowledge with
the Light button. When the symbol
is lit, the
child-proof lock is activated.
- While you are entering the temperature, the set temperature will
flash on the display.
- You can change the settings in increments of 1°C briefly pressing
the button again.
- The electronic controls will switch over automatically about 5
seconds after the last time you pressed the button, and the
actual temperature will be displayed.
If F1 appears in the display, the appliance has a fault. Consult
your nearest customer service point.
Audible warning signal
The audible warning signal helps to protect your wines against
excessive temperature fluctuations.
- It sounds when the door has been left open for longer than about
60 seconds.
- It sounds when the interior gets too warm or too cold. The
temperature display will also flash. The audible warning
device is switched off by pressing the ALARM button.
Fan button
Thereby a climate which corresponds to that of a wine cellar is
achieved inside the wine cooler. Corks are prevented from drying
out due to an increased level of humidity.
To switch on:
Hold down the Alarm button and then press the Light button.
The LED will come on.
To switch off:
Hold down the Alarm button and then press the Light button.
The LED goes dark.
> For h = brightness, press the UP / DOWN button to select
h1 = minimum to
h5 = maximum brightness and acknowledge
with the Light button.
Exiting set-up mode:
Exit the set-up mode by pressing the ON / OFF button; after 2
min. the electronic system switches over automatically. The normal
operating mode is activated again.
Equipment
Pull-out grid shelf
The pull-out grid shelf allows
bottles of wine to be removed
more easily.
Labels
The appliance is supplied with
a label holder with labels for
each shelf. Use these to label
the type of wine stored on each
shelf. Use a soft pencil on the
labels so that you can erase it
again when necessary. Additional labels can be obtained
from your dealer.
Fitting:
Click the label holder into
place and slide the label in
from the side.
8
GB
Interior light
Cleaning
The interior light is fitted on the inside at the top.
Before cleaning always switch off the appliance. Pull out the
mains plug or remove/unscrew the fuse.
The interior light can be switched on and off using the
Light button.
To change the tube
Pull out the mains plug or remove/unscrew the fuse.
• Unscrew the cover panel.
• Change the fluorescent tube.
• Replace cover panel and screw into place.
Do not use steam cleaners because of the risk of injury and
damage.
• Do not use abrasive sponges or scourers, do not use concentrated
cleaning agents and never use cleaning agents containing sand,
chloride or acid or chemical solvents, as these would damage
the surfaces and could cause corrosion.
• Use a glass cleaner to clean the glass surfaces and a commercially
available stainless-steel cleaning agent for the stainless-steel
surfaces.
• Clean the inside and equipment with lukewarm water and a little
detergent, with the exception of the wooden trims on the grid
shelves.
• Ensure that no cleaning water penetrates into the electrical
components.
• Dry all parts well with a cloth.
• Do not remove the type plate from the inside of the appliance;
it is important for after-sales servicing.
Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
Air exchange with activated charcoal filter
The way in which wines continue to mature depends on the ambient
conditions. The quality of the air is therefore decisive for preserving the wine. An activated
charcoal filter has been fitted in the lower area of the
rear wall of the appliance to
ensure that the air throughput remains at an optimum
quality. We recommend that
you replace the filter once a
year. Filters can be obtained
from your dealer.
Changing the filter:
Take the filter by the handle.
Turn it 90° to the left or right
and remove.
Inserting the filter:
Insert with the handle in
a vertical position. Turn it
90° to the left or right until
it clicks into place.
Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the socket fuse intact?
Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects
to vibrate? Please note that noises caused by the refrigerant
circuit cannot be avoided.
The temperature is not low enough:
– Is the temperature setting correct (see "Setting the temperature")?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes
apply and you cannot rectify
the fault yourself, contact the
nearest customer service department stating the type of
appliance ➊, service number
➋ and appliance number ➌ as
indicated on the type plate.
Shutting your appliance down
Bottle holders
Bottles on the pull-out shelf can
be protected from falling over.
Click the enclosed bottle holders
into place and move forwards or
backwards as required.
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or remove the fuse. Clean the appliance and leave the door open in order to prevent unpleasant
smells.
The refrigerant circuit has been tested for leaks.
The appliance is radio-suppressed to EN 55014 and thus complies
with EC Directive 87/308/EEC.
All types and models are subject to continuous improvement and
the manufacturer therefore reserves the right to make modifications to the shape, equipment and technology.
9
Download PDF