Shadow Zero Black 2.0kW Ceramic

Shadow Zero Black 2.0kW Ceramic
Safety Instructions
and Operation Manual
Introduction
Your infrared heater is heating in the way of radiation (no need for medium) so your infrared
heater is effective.at the same time ,the heater has very good physiotherapy effect Because it
doesn't need to heat the ambient air (medium), it is good to be used in the open-air as well.
Important Safety Instructions
When using electrical appliances, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, or injury to persons, etc.
Read through the operation and assembly instructions conscientiously before operating the
appliance.
Be sure to keep the manual in a safe place for future reference. If you pass the appliance on, pass
on the instructions too.
• Check if the voltage indicated on the nameplate of the appliance corresponds to the local
mains voltage before you connect the appliance.
• The power supply to the appliance should correspond to the relevant regulations of the power
supply companies and the regional construction regulations. Extension cords and multi-sockets
may be used only if care is exercised in their use. The marked electrical rating of the extension
cord or multi-socket should have adequate current carrying capacity and correspond to the
relevant regulations of the power supply companies and the regional construction regulations.
Check if the voltage indicated on the appliance corresponds to the marked electrical rating of
the extension cord or multi-socket before you connect the appliance.
• The appliance is not located immediately below a wall socket-outlet.
• Never install this appliance close to anything combustible material, such as furniture, curtains,
etc.
• In order to avoid overheating and fire hazard, do not cover or obstruct the appliance. Do not
put any of the following materials on the appliance, such as clothes, blanket, pillow, paper etc.
• The appliance become extremely hot during operation. Pay attention that, no combustible
material due to Wind or other environmental influences covers or obstructs the appliance, such
as curtains, marquees, flags, plastic foil etc. Do not touch the appliance. Caution! Risk of scald
injury!
• Do not let the cord hang over edge of table or counter, or touch hot surfaces.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
• In case of improper use, there is a risk of electrical shock and/or fire hazard. Operation of the
appliance must be discontinued and remove the mains plug immediately. Do not try to repair
the appliance by your-self. Please contact with the service agent or a suitably qualified
electrician for maintenance.
• Remove the plug from the power outlet and wait until the appliance is sufficiently cooled off
before cleaning.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Keep out of reach of children. In order to keep children from the dangers of electrical
1
appliances, never leave them unsupervised with the machine. Consequently, when selecting
the location for your machine, do so in such a way that children do not have access to the
machine. Children being supervised not to play with the appliance.
• The appliance must only be mounted by an authorized specialist, paying attention to the
relevant regulations of the power supply companies and the regional construction regulations.
• Do not use this heater with a programmer, timer, separate remote-control system or any other
device that switches the heater on automatically, since a fire risk exists if the heater is covered
or positioned incorrectly.
• – the fireguard of this heater is intended to prevent direct access to heating elements and must
be in place when the heater is in use;
Figure1: Mounting bracket and anchor dowels
provided. Connection from the wall to the infrared
heater.
Figure2: Min. distance to floor, ceiling and wall.
Figure3: Tilt angle.
Figure 4: Max.remote distance
Installation
For additional protection the installation of a residual current device (RCD) is advisable.
Remove all package material (including anti-vibration object of the lamp) and check the
appliance, supply cord and the plug for signs of damage.
Pay attention to the mounting place and all mounting material(dowels, screws). Ensure they
are suitable and stable enough for mounting and lastingly holding of the appliance.
Before mounting, the minimum safe mounting distances and tilt angles shown in the figures
must be strictly followed.
1.
The distance between the bottom edge of the appliance and the floor must be at least
1.8 M.
2.
There must be a distance of at least 0.2 M between the appliance and the ceilings, roofs
or other covers.
3.
There must be a distance of at least 0.5 M at each side between the appliance and walls
or the like. See figure 2.
4.
Remember that degree to mounting surface is 45°.
Pay attention that, the installation of the appliance must not add excessive wind load.
Fix the mounting bracket on the wall first. Ensure that the place to be installed is secure and
firm. Or connect the appliance to the stand.
Adjust the desired angle of radiation and fest screw all screws. Check regularly the screws’
connection. Mechanical bearing pressure and oscillation due to wind or rain could lead to
loose.
Plug in the power source. Then observe, whether during the first 10-15 minutes the appliance
works trouble-free.
2
3
Specifications
Cleaning and Maintenance
Specification
LDHR070C-200EKY
Voltage (V)
Power consumption (W)
Dimensions
W×H×D (cm)
220-240V
1950W
94.0×10.0×8.3
Remote Control Instructions
Button
Function
Feature
1. Turn on the heater;
On
On
1.Turn off the heater;
Off
Disposal
2. Receiver light in heater will turn Red with 100﹪
power output..
Off
• Before cleaning, remove the plug from the power outlet and wait until the appliance is
sufficiently cooled off.
• Wipe the appliance only with clean and lint-free cloth or a soft brush.
• Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!
• The alcohol can be used to clean the appliance. When cleaning the reflector , please contact
with the service agent or a suitably qualified electrician if the reflector needs to be removed
• To protect against electrical shock and danger of life, do not immerse cord, plug, or any part of
the appliance in water or other liquid.
• For heating element replacement ,please contact the manufacturer or its service agent or a
similarly qualified person.
2.The receiver light will be flash in Red color if the
heater connects to the power supply.there will be no
indication after cutting off the electricity.
Notice:
Use 2 pieces AAA size1.5V batteries in the remote control.Remove the battery when not use for long
time,thus the lifespan of remote control can be extended.
Choose the same specification battery when replacing the battery inside,otherwise it may cause
remote control not work ,thereby affect the normal use of the heater.
Please contact service agent for further help if you need the function.
The remote control function may be out of work if there is a barrier between the remote control and
heater .
Replacing the batteries duly so as not to affect the normal use of heater and remote control.
4
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
Customer Service
Repairs must be carried out by authorize specialists, thus ensuring electrical safety. Please contact
with the service agent or a suitably qualified electrician.
Improper repairs could lead to danger to the user.
This warranty does not cover damage of failure which results from alteration, accident, misuse,
abuse, neglect, commercial use or improper maintenance.
In line with our policy of continuous product development we reserve the right to change the
product and documentation specifications without notice.
5
Download PDF

advertising