USER MANUAL
150W, 300W, 600W, 1500W
Pure Sine Wave
Power Inverter
Greeting from RND
Dear Customer,
Thank you for your preferred choice in purchasing our RND inverters. Our power
when traveling, outdoors camping, at sea, etc. Low DC current is converted into
series can be used to operate most TVs, VCRs, sound systems, PCs & laptops,
whenever and wherever you are.
You will have to install and use your RND inverters properly according to our
Sincerely yours,
RND.
2
General safety,
installation, & operating
guidelines
GENERAL SAFETY
•
•
• 3Failure to properly connect wiring between inverter and power source will
result in reverse polarity. Reverse polarity will blow the internal fuse in the
inverter and permanently damage said inverter. Damage caused by reverse
polarity is not covered under RND warranty.
•
•
•
capacitors within the inverter.
•
shock.
•
3
•
abnormally warm.
•
30 to 60 minutes and let it run for approximately 10 minutes to recharge the
•
• Always disconnect the inverter when not in use.
• Do not expose the inverter to moisture.
• Avoid placing inverter near sources of heat or under direct sunlight.
•
General safety,
installation, & operating
guidelines
equipment or appliance. The inverters of 600W, 1500W are designed to
4
Some refrigerators, freezers, pumps and other similar equipment and appliances
made and that the power source is fully charged. Then, follow step by step
range. Turn inverter switch OFF, ON, OFF, and ON again in quick succession. If
unsuccessful, it is likely that the inverter model does not have the required start up
INSTALLATION
2. Cables. Make sure to use the correct cables. A chart is provided below, for your
reference:
150W
15A
#14
300W
30A
#10
600W
60A
#6 or 2 x #10
1500W
150A
2 x #4
3. Grounding. Connect Chassis Ground Terminal Lug to earth ground or vehicle
chassis using #8 AWG wire.
5
General safety, installation,
& operating guidelines
OPERATIONAL GUIDELINES
Step 1 Remove inverter from its packaging. Check to verify
Step 2 Connect the cables to the Power Input Terminals
screws excessively.
12V / 24V power source.
12V / 24V power source.
the LED indicators. LED indicators should be lighted.
6
Step 7 Plus the equipment/ appliance into the AC
receptacle at the front panel of the inverter. Leave the
equipment/ appliance switched OFF.
Step 8 Set the power switches of both inverter and
inverter is now ready to transfer power to the equipment/
appliance.)
7
150W Pure Sine Wave Inverter
…………………….………150W
Maximum Surge Capability (Peak Power)…………..……..300W
No Load Current Draw
* 12V DC-115VAC ………………………..……< 0.5A
* 24V DC-115VAC………………………..…….< 0.3A
* 12V DC-230VAC ………………………..……< 0.6A
* 24V DC-230VAC………………………..…….< 0.4A
DC Input Voltage Range
* 12V DC………..……………………………10.5V– 16.5V
* 24V DC………………………………….…..…21V – 33V
AC Output Voltage Range………………………..….115V/230V +/- 3%
………………………………………………………..> 85%
* 12V DC………………………… .…….….…..10.5V
* 24V DC…………………………………….…..21.0V
* 12V DC……………………… ………..……...10V
* 24V DC………………………………..……….20V
Wave Form…………………………………..……… ……..Sine Wave
Dimensions (L x W x H)……………………………..210 x 147 x 66
Net Weight………………………………………………..….…..1.28 kgs
8
*Green : Power On
*Orange : Over Temperature, Over Voltage & Low Voltage
*Over temperature *Overload
*Short circuit
300W Pure Sine Wave Inverter
…………………..…………300W
Maximum Surge Capability (Peak Power)……….….…..….500W
No Load Current Draw
* 12V DC-115VAC……………………………..< 0.5A
* 24V DC-115VAC……………………………..< 0.4A
* 12V DC-230VAC……………………………..< 0.7A
* 24V DC-230VAC……………………………..< 0.5A
DC Input Voltage Range
* 12V DC………..……………………………10.5V– 16.5V
* 24V DC………………………………….…..…21V – 33V
AC Output Voltage Range………………………..….115V/230V +/- 3%
………………………………………………………..> 85%
9
* 12V DC…………………………….………….10.5V
* 24V DC………………………………………...21.0V
* 12V DC…………………………….………….10V
* 24V DC………………………………………..20V
Wave Form…………………………………..………………Sine Wave
Dimensions (L x W x H)……………………………210 x 147 x 66 mm
Net Weight……………………………………………………….1.4 Kgs
*Green : Power On
*Orange : Over Temperature, Over Voltage & Low Voltage
*Over temperature *Overload
*Short circuit
600W Pure Sine Wave Inverterr
15 Minutes Power………………………………………………650W
10
Maximum Surge Capability (Peak Power)………………...1000W
No Load Current Draw
* 12V DC-115VAC………………………….……<0.6A
* 24V DC-115VAC…………………………….…<0.45A
* 12V DC-230VAC……………………………….<1A
* 24V DC-230VAC…………………………….…<0.6A
DC Input Voltage Range
* 12VDC……………………………………….10.7V–16.5V
* 24VDC..……………………………………..21.4V – 33V
AC Output Voltage Range ……………………………115V/230V +/- 3%
………………………………………………………...> 85%
* 12V DC………………………………………….10V
* 24V DC………………………………………….20V
Wave Form……………………………………………………Sine Wave
Dimensions (L x W x H)……………………………280 x 236 x 82 mm
Net Weight………………………………………………….….…2.46 Kgs
*Over temperature *Overload
*Short circuit
11
1500W Pure Sine Wave Inverter
10 Minutes Power..…………………..……………………..…1800W
Maximum Surge Capability (Peak Power)……………..…..3000W
No Load Current Draw
* 12VDC-115VAC……………………………….<1A
* 24VDC-115VAC……………………………….<0.6A
* 12VDC-230VAC……………………………….<1.6A
* 24VDC-230VAC……………………………….<1A
DC Input Voltage Range
* 12VDC………………………………………10.7V– 16.5V
* 24VDC………………………………………21.4V – 33V
AC Output Voltage Range…………………………….115/230V+/ -3%
……………………………………………………….> 85%
* 12V DC…………………………………………10V
* 24V DC…………………………………………20V
Wave Form…………………………………………………..Sine Wave
Dimensions (L x W x H)………………………….415 x 283 x 100 mm
Net Weight………………………………………….……………5.75 Kgs
12
*Over temperature *Overload
*Short circuit
Output Power
DC input
AC Ouput
150W
12V
230V
300W
12V
230V
RND 320-00009
24V
230V
600W
12V
230V
RND 320-00010
RND 320-00013
24V
230V
1500W
12V
230V
RND 320-00011
24V
230V
RND 320-00008
RND 320-00012
RND 320-00014
All 230V models are CE and E-mark Compliance. Should you have
maintenance of this inverter unit, please get in touch with our
customer service.
13
Distrelec Group AG
Grabenstrasse 6, CH-8606 Nänikon
Download PDF