rotary laminator - Union Tool Corporation

P
R
O
D
U
C
T
B
U
L
L
E
T
I
N
ROTARY LAMINATOR
The Union Tool Corporation
P.O. Box 935
Warsaw, IN 46581-0935
Phone: 574/267-3211
Fax:
574/267-5703
PB #21327
E-Mail: info@uniontoolcorp.com
Website: www.uniontoolcorp.com
ROTARY LAMINATOR
The Union Series #15, 50” wide Rotary Laminator was designed to apply bonding pressure for the
purpose of laminating two substrates or web materials together. Union Series #15 Rotary Laminators
are available in any width up to 62” wide.
This Series #15 RL pinch roll machine incorporates two 6-1/2” diameter rolls with a 1” rubber covering.
Both rolls are chain-driven through a 1/2 HP variable speed motor. The upper roll is adjustable in
relationship to the bottom roll in a range from 0” to 4”. A single handwheel raises or lowers mechanical
stops located on each end of the machine. Air cylinders attached to the upper roll lowers the upper roll
against these mechanical stops so that an accurate gap setting can be made. A mechanical digital
indicator readout allows the operator an exact measurement of the gap setting.
The 4” diameter air cylinders provide an adjustable amount of laminating pressure up to a maximum
of 1,300 pounds of pressure per cylinder at 100 psi. This relates to 52 pounds of line contact pressure
per linear inch of a 50” wide machine. 6” diameter cylinders are also available for applications
requiring even more pressure.
This laminator may be used in either a forward or reverse direction and includes a selector switch to
control the direction. The raising and lowering of the upper roll is also controlled at the push-button
station mounted to the machine. The machine is complete with a disconnect box. The standard
voltage is 220/440 volt, 3 phase. The mounting location of the push-button controls and gap
adjustment wheel can be specified by the customer.
A safety cable wrapped around the perimeter of the machine automatically stops the revolving rolls
and fully raises the top roll when activated.
Other features that may be added to this machine include unwind stands (for roll materials), infeed
and/or outfeed conveyors as well as rewinds or sheet stackers.
Call Union Tool for your laminating requirements.
The Union Tool Corporation
P.O. Box 935
Warsaw, IN 46581-0935
574/267-3211
Fax: 574/267-5703
E-mail: info@uniontoolcorp.com
Website: www.uniontoolcorp.com
21327
Download PDF

advertising