Modular Stainless Steel Countertops
Technical Data
Part 1 – General
1.1 SCOPE OF WORK
A. Includes all factory fabricated stainless steel Countertops and Sinks as required by
the project drawings.
1.2 TYPICAL INCLUSIONS
A. Countertops and Work Surfaces.
B. Legs and Wall Bracket supports.
C. Inset, Drop-in, Under mount, and Scullery Sinks.
1.3 TYPICAL EXCLUSIONS
A.
B.
C.
D.
Wall framing and in-wall backing for anchorage support.
Electrical.
Mechanical.
Work not directly associated with these stainless steel components.
1.4 MATERIALS
A. Components fabricated from T304 stainless steel sheet, (T316 stainless steel
available at additional cost) conforming to ASTM A240. All exposed surfaces
polished to a No.4 brushed satin finish. (150/180 grit.)
1.5 SHOP DRAWINGS
A. Submit complete shop drawings showing elevations, plans, cross sections and
installation details.
B. When locks are specified a complete keying schedule will be submitted with
proposed keying for review by Architect and Owner.
1.6 SAMPLES
A. Samples are available on request for Architect and Owner review and acceptance,
The sample, if approved, may be incorporated into the project.
1.7 DELIVERY, STORGE AND HANDLING
A. Schedule delivery of equipment per the customer so that spaces are sufficiently
complete to allow for installation immediately following delivery.
B. Protect finished surfaces from soiling or damage during handling and installation,
Cover working surfaces with cardboard, Mark in large lettering "NO STANDING”
Part 2 – Products
2.1 DESIGN REQUIREMENTS
A. Straight, L-shaped, and U-shaped Countertops and Sinks are designed to
accommodate the Architect’s or owner’s plans.
B. Fixture holes at sinks are provided free of charge but must be specified before an
order is released for fabrication.
2.2 CONSTRUCTION
A. Countertops, work surfaces and sinks are fabricated from #16 gauge T304
stainless steel, ASTM 240, with a No. 4 brushed satin finish, all corners are coved
with a 3/4 in. radius.
B. Under sides of countertops and work surfaces are sound deadened.
C. Exterior of sinks are sound deadened where unexposed within casework.
D. Exposed stainless steel sink bowls are polished on exposed sides, and sound
deadened on bottom.
E. Sinks are furnished with stainless steel basket drain and 1 1/2” X 4” tailpiece as an
option.
F. NSF rated sound deadening is available.
G. Legs are either 1 5/8” round or 2” square #16 gauge T304 stainless steel tubing
with the same No. 4 brushed satin finish.
H. Wall Bracket supports are #14 gauge T304 stainless steel with the same No. 4
brushed satin finish.
I. Sinks are fabricated from #18 gauge T304 stainless steel, ASTM 240, with a No. 4
brushed satin finish.
Part 3 – Protection of Finished Work
3.1 PROTECTION OF FINISHED WORK
A. Products shipped with protective PVC film to help prevent surface damage in
transit.
B. Provide all necessary protective measures to protect countertops and equipment
from exposure to other construction activity during installation.
C. Advise contractor of procedures and precautions for protection of installed
countertops and other equipment from damage by workers from other trades.
Download PDF