Leak Protector By Watts

Leak Protector By Watts®
International Patents Pending.
Don’t let this happen to your customers!
Protect yourself from potential leaks due to high water pressure,
customer issues or installation mishaps.
Leak Protector by Watts® “detects” and “protects”.
This unique Leak Protector by Watts not only detects leaks,
it also shuts off flow to a drinking water system in the event
a leak should occur. This unique device is a small up-front
investment, designed to eliminate possible damage to
homes and business property.
How it works!
The patented device is novel, but quite simple. When a
leak occurs, the adsorbent applicator “tablet” expands to
close the valve and shut off the incoming water supply.
Two tablets are included with each Leak Protector,
and replacement tablets are available, packaged
two per pack.
Maximum oiperating pressure = 100 psi
Maximum ambient humidity = 70%
Leak Protector
Adsorbent Applicator Pads
CAUTION:
Keep Leak Protector Replacement Cartridges (pads) out of the reach of children.
Part Number
LPSOV
LPSOV-PAD
Description
Qty. Per Case
Leak protector & shut off valve with two applicator tablets (1)
25
Replacement applicator tablets (package of 2)
2
Drinking Water Components
Leak Protector & Shut-Off Valve by Watts®
Detects leaks and shuts off automatically when leaks are detected, reducing liability claims.
Ideal for under counter RO and drinking systems!
Valve Installation
Step 1
Turn off the water supply to the filtration system at the cold
water source valve.
Step 2
The leak detecter should be mounted flat in the lowest
ground point near the filtration system so in the event a leak
occurs the water will flow in the direction of the valve.
Step 3
Clean the designated installation area with rubbing alcohol.
Step 4
Peel the red backing tape from the two mounting feet on the
base of the shut off valve and press down firmly over the
chosen install area. You may also mount the valve using the
screws included in the kit.
Step 5
Cut the systems water supply tube to splice in the valve.
Connect the tubing from the water source valve to the
horizontal fitting on the shut off valve labeled “in” by
pushing the tubing in firmly until fully seated.
Step 6
Connect the tubing leading from the filtration system to the
vertical fitting on the shut off valve labeled “out” by pushing
the tubing in firmly until fully seated.
Step 7
Turn on the water supply to the filtration unit and check
for leaks.
Replacing The Tablet
Step 1
Turn off the water supply at the cold water valve.
Step 2
Using a Phillips screwdriver, loosen and remove screw from
the top of the valve.
Step 3
Twist the upper white assembly counter clockwise, lift up and
remove old tablet.
Step 4
Make sure the valve and the surrounding area is dry before
replacing the tablet.
Step 5
Insert the new applicator tablet into the clear plastic housing.
Step 6
Replace the upper white cap onto the clear plastic base by
twisting it clockwise until seated.
Step 7
Replace Phillips screw and tighten (do not over tighten as
this may damage the valve unit).
Step 8
Turn on the water supply to the filtration unit and
check for leaks.
CAUTION:
Keep Leak Protector Replacement Cartridges (pads) out of the reach of children.
Drinking Water Components
Part Number: LPSOV
Replacement Pads: LPSOV-PAD