Always unplug the power cord before installing or

Assembly Instructions for: item 3033
Candle series - Triple Floor Lamp
Important: Always unplug the power cord before installing or replacing bulb and before cleaning or other maintenance.
FIG. A
FIG. B
socket cup
glass shade
upper stem
clutch
bulb
threaded pin
lower stem
coiled cord
base
power cord
socket cup
full range floor
dimmer
LAMP ASSEMBLY
1. Loosen clutches and extend upper stems to pull coiled cords inside lower stems.
2. Screw the lower stems of each lamp on to the base. (Fig A)
3. Install 60 watt,E12 candelabra base bulbs (not included). Frosted bulbs are
preferred.
3. For each lamp, position glass shade over socket cup, aligning the holes in the
shade with the threaded holes in the socket cup. Secure glass with the three threaded
pins. (Fig B)
HEIGHT ADJUSTMENT
•To increase height of lamp, loosen the Clutch and carefully pull
up on the Upper Stem. Tighten the Clutch once lamp is at
desired height. (Fig. A)
•To decrease height of lamp, loosen the Clutch and carefully
push down on the Upper Stem. Tighten the Clutch once lamp is
at desired height.
SL.032 REV.02