interceptor - Swedish Radio Supply

Power Off
Press and hold the power button
on the Interceptor until LED
flashes RED then release.
MICROPHONE
INTERCEPTOR
VOLUME CONTROL
Quick guide
PTT 1
EARPHONE /
MICROPHONE
CONNECT & GO
JACK
PTT 2
SPEAKER
88 mm
Power On
Press and hold the power button
on the Interceptor until first LED
appears then release.
60 mm
USB CHARGING
Pair to a Two-Way Radio with
dongle
Press and hold the power button on the Interceptor until LED
flashes BLUE/RED then release. With the Bluetooth adapter
(dongle) connected to the radio,
press down on the clear PTT
button on the dongle and turn
the radio on at the same time.
When dongle is flashing BLUE/
RED release. When both dongle
and Interceptor are solid BLUE
for a moment both units are
paired. No need to repeat the
pairing process when this is
achieved. Depending on the
dongle, turn on radio, turn on
Interceptor for automatic linking.
Pair to a Two-Way Radio with
Built-In Bluetooth
Press and hold the power button on the Interceptor until LED
flashes BLUE/RED then release.
Then quick press the large PTT
button once. Make sure the radio is in pairing mode. Search
for the word Interceptor on the
radio, then pair. No need to repeat the pairing process when
this is achieved. Next time the
units are used just power up the
radio, power up the Interceptor
and the units should automatically link.
Priority setting
Double press power button twice then large PTT once to redirect PTT status.
To Charge
Connect the USB cable to the
micro USB port on the Interceptor, connect the other end to a
USB charging bank or supplied
wall charger. LED will flash RED.
When charging is complete LED
will show solid RED. Charge
time, about 3.5 hours.
Pairing: Red, blue fast flash
Pairing
complete: Solid blue
momentarily
PTT pressed: No LED
PTT released: No LED
Charging: Red Flash
Fully Charged: Solid Red
Battery low: Red, slow flash
PTT (Push-to-Talk)
Press and hold to talk, release
to listen.
Note
Only two devices can be paired
at the same time.
Interceptor automatically times
out the LED to avoid any LED
glow at night.
Volume Control
Long-press the “+” to increase
volume, long-press “-” button to
decrease.
LED Indication
On: Blue, then no LED after 15 seconds
Off: Red Flashes
Idle: No LED
To Pair a Second Device
Repeat pairing process, but
make sure the first paired device is off.