installation instructions :dedeen sloot

INSTALLATION INSTRUCTIONS
TOOLS NEEDED:
DO NOT USE:
1. Turn off water supply. Flush toilet and remove excess water
from tank with sponge. Remove water supply line from
bottom of toilet fill valve.
3. Install bolts as follows: Slide rubber washer under bolt head
and insert bolt through tank. Install brass washer, then thread
hex nut onto bolt. Carefully tighten bolt until snug. Check
tank-to-bowl gasket. If worn, replace with Fluidmaster Model
6100 gasket.
RUBBER WASHER
{
OPTIONAL
2. Unbolt tank from bowl, lift off tank. Remove washers, nuts
and bolts from bottom of tank.
BOLT
TANK
BRASS WASHER
HEX NUT
BOWL
RUBBER WASHER
BRASS WASHER
WING NUT
4. Place tank back on bowl so that sponge gasket fits evenly.
Install rubber washer, brass washer, then wing nut onto bolt.
Repeat for other side. Tighten nuts evenly. DO NOT
OVERTIGHTEN or bowl may crack.
5. Reconnect water supply line to toilet tank fill valve. Turn on
water supply.
© 2011 Fluidmaster, Inc. All rights reserved. This document is not a substitute for the product
instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be
liable for any damages resulting from failure to install or maintain the product in accordance
with the product instructions, from abuse or misuse of the product, from use of
non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl
cleaners containing bleach or chlorine.
®
30800 Rancho Viejo Road
San Juan Capistrano, CA 92675 U.S.A.
www.fixthistoilet.com